World Dryer Q-Series VERDEdri Instruction Manual - Coarse Particulate Filter

Manual is about: Hi-Speed Surface-Mounted ADA Compliant Hand Dryer

Page of 9

Download

Print this page

Bookmark us

Coarse Particulate Filter

(for models not including HEPA filters)

The dryer has a coarse particulate air filter to prevent lint and debris build up that can damage the

motor and heating element. Routine replacement or cleaning of the air filter is needed to maintain

the dryer in good operating condition. With light to moderate wash room traffic, replacing or

cleaning the air filter once a year is recommended. If the wash room traffic is high, the air filter

should be replaced or cleaned every 6 months. Read complete instruction before proceeding.

To replace or clean the coarse particulate air filter:

1. Disconnect the power source.

2. Use the security hex key supplied to turn the cover mounting screws

clockwise

to remove the cover from the dryer.

3. Removing and replacing the air filter is easily done by gently pulling the filter away from the filter housing.

4. To clean the coarse particulate air filter, remove from filter from the filter housing. Use soft-medium bristle ½” paint

brush to clean lint, dust and debris from the filter. If air filter cannot be completely cleared of debris, replace the filter.

5. After replacing the air filter into the filter housing, reassemble the dryer cover using the security hex key supplied to

turn the cover mounting screws

counter-clockwise

and tight until snug. Do not over tighten.

6. Reconnect the power source.

Diagnostic LED’ Display

The printed circuit board includes a set of LED’s that indicate the operational status of the hand dryer. When

contacting World Dryer Technical Service, be prepared to remove the dryer’s cover and provide the condition of

the LED’s as they can be helpful in troubleshooting the dryer. See Figure 1 for location of diagnostic LED’s on the

printed circuit board. See Table 4 for an explanation of LED function.

Diagnostic LED Function

Table 4

IR Sensor Activity

Dryer Speed

Supply Voltage Detected

Indication

LED 5

LED 4

LED 3

LED 2

LED 1

Flashing

Power Supply Voltage is less than

100V or greater than 255V

OFF

Red

Power Supply Voltage is 110 –

120V

OFF

Yellow

Off

Power Supply Voltage is 208V

Light Green

OFF

Power Supply Voltage is 240V

Blue

Motor speed is set at low speed

Green (solid)

IR sensor detects hands or object

in sensing zone

Flashing Green

In vandal-resistant “lock out” mode

(check for sensor obstruction)

« ‹ Prev 3 4 5 6 7 8 9 Next › »

Summary of Q-Series VERDEdri

Page 1
Ifs ltd t/a intelligent hand dryers uk www.Intelligenthanddryers.Com 0114 286 6394.
Page 2: Verdedri
Verdedri hi-speed surface-mounted ada compliant hand dryer all “q” series todos los modelos de la serie “q” toutes les séries q alle geräte der serie „q“ tutti i modelli “q” please read and save these instructions. Read carefully before attempting to assemble, install, operate or service the product...
Page 3: Description
2 description world warm air hand dryer is a surface-mounted ada (american disabilities act) compliant dryer powered by a universal brushed motor, and delivers up to 950 watts of drying power. These models operate at all voltages 115 – 230vac, incorporate an integrated heating element, blower speed ...
Page 4: Unpacking
3 unpacking 1. Remove all packing material. Recycling is recommended. 2. Carefully remove the hand dryer from the shipping carton, using care not to drop the appliance. 3. Inspect carefully for any damage that may have occurred during transit. Check for any loose, missing or damaged parts. If the ha...
Page 5: Adjusting Blower Speed
4 these models include adjustable blower speed control for (2) levels of operation – hi, and low. The switch is located on the printed circuit board inside the dryer as shown in fig. 1 below. Note: the factory setting for the blower speed control is “hi”. To adjust blower speed: 1. Disconnect the po...
Page 6: Parts List
5 repair parts list for verdedri ™ hand dryer parts list # description part number 1 kit, dryer controls with sensor and transformer 16-10283k 2 kit, motor 32-10268k 3 kit, replacement motor brushes 32-10337k 4 kit, heating element 21-10306k 5 kit, front plenum – with seal 47-10270k 6 kit, motor cap...
Page 7: Hepa Filter Replacement
6 maintenance and cleaning instructions important: the dryer may collect lint and debris that is naturally present in the air. Excessive build up of lint and debris can damage the motor and heating element. The dryer should be cleaned on a routine schedule to maintain the dryer in good operating con...
Page 8: Coarse Particulate Filter
7 coarse particulate filter (for models not including hepa filters) the dryer has a coarse particulate air filter to prevent lint and debris build up that can damage the motor and heating element. Routine replacement or cleaning of the air filter is needed to maintain the dryer in good operating con...
Page 9: Limited Warranty
8 limited warranty world limited five – year warranty. World warm air hand dryer, model covered in this manual, is warranted by world dryer corporation to the origi- nal user against defects in workmanship or materials under normal use for 5 years after date of purchase excluding normal wear and tea...