X-Loupe G-series User Manual - page 8
page 12
page 13
Assembling
Assembling
As picture shown on the left, tuck Canon digital camera into
X-Loupe® module.
Make sure that the screw hole on the bottom of the module is
aligned with the tripod socket of the camera. Insert the screw
into the hole.
Rotate a coin clockwise to tightly lock the screw. Please make
sure that both Canon digital camera and the module are well
locked.
Make sure that the left and bottom edges of the Canon digital
camera are in close contact with X-Loupe® module.
Hold the camera and module in one hand and take the
objective lens with the other hand. Align the red dot on the
objective lens with the other red dot on the module.
Attach the objective lens to the module.
Rotate the objective lens clockwise until the sound,'ka',
is heard. Do not over-rotate the objective lens.
To change the objective lens, press
the release button and rotate the
objective lens counterclockwise for
45 degrees. Easily and softly disas
semble the objective lens from the
module. Do not over-rotate the
For the safety purpose, please make sure that the objective
lens is not loose.
To disassemble X-Loupe® module from Canon digital camera, rotate a coin
counterclock wise. Pay attention to both camera and module to prevent them from
falling . Please store the screw in a proper place, It is advised to put it back into the
carrying case.
objective lens. Repeat above procedures to assemble another objective lens onto the
module.