Summary of XMP3-128
Page 1
X-micro mp3 player user manual.
Page 2
1 table of contents 1. Introduction 1.1 about x-micro mp3 player -----------------------------------------------------2 1.2 features -----------------------------------------------------------------------------3 2. How to use x-micro mp3 player 2.1 mechanical parts-----------------------------------...
Page 3
2 important notice: some of computers may have power leaky or other problems, to avoid any direct damage caused to mp3 player, we suggest you use extension cable, usb hub or docking station to connect mp3 player to your computer. Do not straightly plug mp3 player to computer. 1. Introduction 1.1 abo...
Page 4
3 1.2 features - current available: 64mb / 128mb / 256mb - support music format: usb mp3 - earphone jack: 3.5 mm - audio output: 5mw+5mw - output frequency range: 20hz – 20khz - battery: lithium-ion 500ma 3.7v, continue using player at least 20 hours at full-charge. - support usb specification revis...
Page 5
4 2. How to use x-micro mp3 player 2.1 mechanical parts 2.2 how to install battery 1. Please connect mp3 player to usb port to charge battery. When first time use it, please ensure charging time at least 1 hours and 45 minutes. 2. Charger adapter optional..
Page 6
5 2.3 function: usb mp3 player mode 1. Power on when earphone plugged and press for 3 seconds. (earphone port is 3.5mm) 2. Play/pause: press control switch button once. Turn off: press control switch button for 3 seconds..
Page 7
6 3. Slide to right side and hold: volume raise slide to left side and hold: volume low down 4. Quick pull to right side: next song quick pull to left side: previous song volume raise volume down next song previous song.
Page 8
7 5. Power led: (i) orange led on indicates battery in charge. Plug x-micro mp3 player into usb port to re-charge battery through computer. (ii) green led on indicates battery is in full charge. Power led.
Page 9
8 6. Play led: (i) red led indicates you are using usb mp3 player mode. (ii) red led quickly flashes when no usb mp3 file found. (iii) red led slowly flashes when you pause usb mp3 player. (iv) green led indicates you are using usb removable disk mode. (v) green led blinking when you are reading/wri...
Page 10
9 7. To charge battery: take off cap and plug into usb port of notebook or desktop computer to charge battery. For better usage, please charge at least 1 hour and 45 minutes..
Page 11
10 3. How to install / modify / repair / remove driver 3.1 windows 98/98se installation： (1) go to cd or floppy disk driver in “my computer.” (2) execute “setup.Exe” by double click on the icon. (3) follow up the instruction by click “next”..
Page 12
11 (4) system will install all the necessary files into your windows operating system. After setup installation completed, click “ok” to restart computer. Once installation is finished completely, you can see a “removable disk” in “my computer” when you plug mp3 player..
Page 13
12 3.2 modify or repair driver for win 98 / win 98 se (1) if you have installed the driver once before . When execute the “setup.Exe” file again, you will see the following screen. If somehow the driver is wrong or damaged, you can select “repair”. Select “modify” or “repair” and then click “next”. ...
Page 14
13 (3) click “finish” to complete modification..
Page 15
14 3.3 remove driver from win 98 / win 98 se (1) to remove driver from operating system. Execute the “setup.Exe” file from cd driver disk again. Select “remove” and click “next”. (2) system will then ask you to confirm deletion. Click “ok”. (3) this screen may or may not appear. It’s system asks you...
Page 16
15 (4) click “finish” to complete the process of removing device driver from system..
Page 17
16 3.4 windows me / windows 2000 / xp installation for these three operating systems, no driver is needed, because windows has built-in driver to support usb removable disk. Simply plug mp3 player into the usb port and it will be recognized by the system. System will setup mp3 player automatically w...
Page 18
17 5 linux 2.4.0 + / mac 8.6 + installation again, no driver is required for these two operating systems. Simply plug the mp3 player into the usb port and the system will automatically find mp3 player. After using mp3 player, you could unplug mp3 player from the usb port directly once the led stops ...
Page 19
18 important notices ： (i) in os windows 98/98se, if you don’t set up installation firstly, system will ask you to put driver disk for running installation. Be sure to unplug mp3 player before running setup programs. If you install the driver with mp3 player plugged, it may cause setup error or fail...