1. DL manuals
  2. X-PROGRAM
  3. Amplifier
  4. X-D11
  5. How To Install And Operate

X-PROGRAM X-D11 How To Install And Operate

Summary of X-D11

  • Page 1

    In store "130" you can find and buy almost all necessary goods for your auto in kyiv and other cities, delivery by ground and postal services. Our experienced consultants will provide you with exhaustive information and help you to chose the very particular thing. We are waiting for you at the addre...

  • Page 2: X-D11

    How to install and operate the x-d11 digital mono amplifier welcome! This owners manual is written in easy english and uses a lot of drawings to simply the installation and use of the above amplifier. Your x-program amplifier must be installed correctly in order to work well. This manual will show y...

  • Page 3: Installation

    X-d11 include rca input and output high level input with auto start continuous variable low pass crossover continuous variable subsonic crossover bass boost feature remote bass level control phase control cont. Variable 0-180 degrees bridge mode master / slave selector electronic protection circuitr...

  • Page 4

    Tools and material needed tools: flat and phillips screwdrivers wire cutter wire stripper electric drill with drills crimping tool digital multimeter or test lamp wire brush, scraper or a piece of an abrasive sheet to remove paint for a good ground connection grease to protect the ground connection ...

  • Page 5: Wiring

    Wiring power and outputs x-d11 power terminal ( +12v) remote terminal ( rem ) for rca cable signal input: connect the radio power antenna lead = remote turn on/off from the car stereo to the amplifier remote connection. This turns on the amplifier whenever the car stereo is turned on. You can either...

  • Page 6: Input and Controls

    Important use either the low level or the high level input, do not use both at same time. Low level input use a pair of shielded stereo audio cables with rca type jack. Most trunk-mount amplifiers need a 20 feet rca cable ( appr 5 – 6 meters). Most under the seat installations require 12 feet ( 2 – ...

  • Page 7: Single Amplifier System

    X-d11 bass boost control is used to set the bass volume. You can select the amplification between 0 db and +18 db at a 45 hz center frequency. This function is used to compensate for the bass box function and to adjust for your own taste of bass. Set level control at 0 db if you want it to be inoper...

  • Page 8: Bridging Two Amplifiers

    X-d11 bridging two amplifiers remote bass boost control. To remote on head unit ground battery fuse distribu- tion block power cap you can connect t two x-d11 in bridge mode. One of the amplifiers is ”master” that controls the signal to the second amplifier that should be used in ”slave” position. T...

  • Page 9

    Noise problems whining noise varying with engine revolutions: do this: 1. Rewire the power supply (12 v) to source unit direct from battery. 2. Rewire ground wire from source unit to clean position on chassis. 3. Check all power connections to ensure that they are clean and tight. 4. Check quality o...