X-TREME Scooter X-560 Assembly Instructions

Page of 4

Download

Bookmark us

X-560 Assembly Instructions

X-Treme Scooters June 2006

www.x-tremescooters.com/support/

Your X-560 scooter comes 85% assembled. Approximate assembly time = 30 min.

Unpack and locate the following parts:

Tool Kit & Assorted bolt/nuts/washers

Trunk & mounting hardware

Trunk/Cargo Rack

Seat

Seat Post

Rear Tail Light

Left & Right Side Fairings

Assorted Fuses

1. Remove the protective seat post.

This is used for shipping only. Discard

2. Install Handlebars.

Slide the handlebars onto the fork. See

fig. 2 & 3.

Locate the Handlebar Lock Pin, and

insert it into the side of the handlebar,

ensuring it feeds thru the fork bracket.

Secure the lock pin using the attached

bolt. Fig. 4.

Slide the handlebar clamp up and over

the base of the handlebar. Tighten the

clamp ensuring the front wheel is in

proper alignment with the handlebars.

Fig. 5.

After the handlebar is securely

attached, slide the black rubber boot

over the connection.

Fig. 5

Fig. 4

Fig. 3

Fig. 2

Page 1
X-560 assembly instructions x-treme scooters june 2006 www.X-tremescooters.Com/support/ your x-560 scooter comes 85% assembled. Approximate assembly time = 30 min. Unpack and locate the following parts: tool kit & assorted bolt/nuts/washers trunk & mounting hardware trunk/cargo rack seat seat post r...
Page 2
X-560 assembly instructions 3. Attach throttle and brake handle grips. Insert handle grips into the handlebar post, ensuring the gold lock pin protrudes thru the post. Tighten the black, handlebar thumbscrew securely. Fig. 6. 4. Attach left/right side fairings. Locate the following for each side: 3-...
Page 3
X-560 assembly instructions 5. Mount the trunk/cargo rack locate the rear trunk rack bolt. Remove the bolt and set aside. Do not discard! Fig. 10 attach the rack to the seat post. Fig. 11. Re-install the trunk rack bolt securing the rack to the rear of the scooter. Fig. 12. *optionally mount the rea...
Page 4
X-560 assembly instructions 7. Install rear tail light. Insert wire with plug end thru the hole, and connect. Fig. 15. Mount tail light by inserting the bolts thru the two holes and secure with the attached nuts. Fig. 16. Correctly mounted view. Fig. 17 8. Insert the 25amp glass fuse. Locate the spa...