X-TREME Scooter XB-200LI User Manual - Important Information

Manual is about: Super Folding Electric Mini Bicycle

Summary of XB-200LI

  • Page 1

    1 xb-200li / xb-210li super folding electric mini bicycle user manual (photo may vary) please be safe when riding always wear a helmet and obey all laws!.

  • Page 2: Important Information

    2 important information fully charge batteries before first use - batteries should be fully charged immediately when they are received and immediately after each use for the recommended charge times (see below) • l i f e p o 4 lithium batteries: 4-6 hours factors to maximize the range of your electr...

  • Page 3

    3 table of contents important information…………………………………………………………………………………………………….. 2 table of contents……………………………………………………………………………………………………………. 3 getting to know your xb-200li………………………………………………………………………………………. 4 getting to know your xb-210li………………………………………………………………………………………. 5 before you ride…………………...

  • Page 4

    4 getting to know your xb-200li 1. Led headlight 9. Li-ion battery 2. Hand brake 10. Mud flap 3. Hand throttle 11. 300w hub motor and 12” rear wheel rim 4. Left grip with pas (pedal assist system) 12. Chain guard 5. Folding handlebar & stem 13. Right crank arm with chain sprocket 6. Seat 14. Pedal 7...

  • Page 5

    5 getting to know your xb-210li 1. 16” front wheel rim 2. Front brake rotor 3. Winzip front caliper brake 4. Kickstand 5. Winzip rear caliper brake 6. 16” rear wheel rim 7. 300w hub motor **note – all component identified in both images same on for both models except for front wheel rim, rear wheel ...

  • Page 6: Before You Ride!

    6 before you ride! Please read the manual carefully before riding your x-treme™ xb-200li bicycle. 1. Your xb-200li has been equipped with a brake switch-off device. Left and right brake levers are installed with a brake power switch. No matter which brake you use while riding the power will be cut o...

  • Page 7

    7 2 - about this manual it is important for you to understand your new bicycle. By reading this manual before you go out on your first ride, you’ll know how to get better performance, comfort, and enjoyment from your new bicycle. It is also important that your first ride on your new bicycle is taken...

  • Page 8: Operating Process

    8 operating process folding 1.) lift the handlebar lock pin on the left side of the handlebar as shown in figure 1. After you lift the pin you can drop the left handlebar down and rest to the side. 2.) repeat step 1 for the right side as shown in figure 2. Both handlebar sides will be folded down as...

  • Page 9

    9 ! Position. Make any adjustments to the seat height as needed. ***make sure to check that everything is locked into position prior to riding. Seat height in order to obtain the most comfortable riding position and offer the best possible pedaling efficiency, the seat height should be set correctly...

  • Page 10: Bicycle Assembly

    10 ! Battery charging charger indicator – red = charging / green = full battery 1. Plug the connector between the charger and the battery. Next plug the charger to the power source. The led charger will turn red, which means the charger is on and working. 2. When the led light turns green, it means ...

  • Page 11

    11 stem and handlebars 1. Remove the protective shipping cap from the stem wedge. 2. Remove the stem plug from the stem. Loosen the stem bolt with a 6mm allen wrench or 13mm box wrench. 3. Insert the stem into the head tube of the bicycle. Ensure that the minimum 4. Align the stem and handlebar so i...

  • Page 12

    12 do not attempt to disassemble a suspension fork yourself. Contact x-treme scooters for assistance or see a professional bicycle repair technician. If your bike is equipped with a suspension fork, check that the fork compresses and rebounds smoothly. To do this, place the fork dropouts against the...

  • Page 13

    13 the seat to the proper height. The seat post must be inserted to at least the “minimum insertion” line. Move the quick release lever to the closed position. You should feel considerable resistance while moving the lever. If not, re-open and tighten the lever, then move it to the closed position. ...

  • Page 14

    14 disc brakes 1. Check the tightness of the six disc mounting bolts (figure 16) that are holding the brake rotor to the wheel. If you need to remove these bolts, be sure to use a thread-locking compound when reinstalling them. 2. Make sure the two bolts securing the caliper adaptor bracket to the f...

  • Page 15

    15 battery care and information proper maintenance of batteries will maximize their lifespan and capacity. X-treme scooters warranties your new batteries from the date of purchase for 1 full year when properly cared for. Visit www.X-tremescooters.Com/support/ for more information. Battery care even ...

  • Page 16

    16 avoid storing your batteries in extreme temperatures, whether hot or cold. Batteries are best kept in a cool, dry place. Do not allow batteries to accumulate condensation, as this could cause shorting or corrosion. The recommended storage temperature is between 32 - 77° f (0 - 25°c) avoid exposin...

  • Page 17

    17 ! Li-po4 lithium batteries – charge for 4-6 hours for full charge. The charger may get warm to the touch, so make sure you charge your battery in an open area and do not lie anything on the charger unit while charging. Although you cannot over-charge the batteries, we recommend that you do not le...

  • Page 18: Bicycle Care

    18 bicycle care basic maintenance the following procedures will help you maintain your electric bicycle for years of enjoyable riding. 1. After initial set up, be sure to check wheel spokes to make sure they are properly fitted. Be sure to check again after a few rides to ensure proper break in. (th...

  • Page 19: Safety Checklist

    19 safety checklist before every ride, it is important to carry out the following safety checks: 1. Brakes • ensure front and rear brakes work properly. • ensure brake calipers are not over worn and are correctly adjusted. • ensure brake control cables are lubricated, correctly adjusted and display ...

  • Page 20

    20 8. Accessories • ensure that all reflectors are properly fitted and not obscured. • ensure all other fittings on the bike are properly and securely fastened, and functioning. • ensure the rider is wearing a helmet. 9. Motor and throttle • ensure motor is functioning properly. • ensure throttle is...

  • Page 21: Specifications

    21 specifications battery: 24v/8ah lipo4 lithium battery frame: alloy 6061-t6, tig welded front fork: alloy suspension front fork handlebar: alloy, with adjustable alloy handlebar stem with scale cranks and chain wheel: forged alloy cranks and single steel chain wheel brake: f/r winzip disc brakes, ...

  • Page 22: Do Not Return To Store

    22 do not return to store if you need help call or go online 1-253-777-0690 www.X-tremescooters.Com/support/ for general information or parts visit www.X-tremescooters.Com revised 5/22/13.