X-TREME XG-470 Owner's Manual - This Is A 2-Cycle Engine

Manual is about: GASOLINE

Summary of XG-470

  • Page 1

    Please be safe when riding page1 x-treme tm gasoline scooters model: xg-470 product handbook.

  • Page 2: This Is A 2-Cycle Engine

    Always wear a helmet and obey all laws! This is a 2-cycle engine it requires a mixture of gas and 2-stroke engine oil 1. You must always use a gas/oil mixture. Failure to do so will void your warranty! 2. Use 32:1 gas/oil mixture. 4 oz. Of oil for every gallon of high- octane gasoline. 3. Tanaka per...

  • Page 3: Important

    Do not jump or abuse this product! Do not ride in wet/icy conditions! Failure to follow these instructions will void your warranty! If you have any questions, please contact x-treme customer service on the web at www.X-tremescooters.Com page3 warning this product does not conform to federal motor ve...

  • Page 4

    Page4 fuel safety mix and pour fuel outdoors away from sparks or flames. Only use a container approved for fuel do not smoke or allow smoking near the x-treme xg-470 while working on the engine, or while the engine is running. Wipe up and clean all fuel spills before starting the engine. Move at lea...

  • Page 5

    Table of contents important information…………………………………….…..2 quick reference…………………………………………………4 table of contents……………………………….……………...5 getting to know your x-treme xg-470…………………..6 packing contents……………………………………………….7 getting started………………..……………………………..…7 assembly………………………………………………………..7 gas tank i...

  • Page 6

    Tires and wheels…………………………………………..14 adjusting the head unit…………….…………………..14 adjusting the chain…..………..……………….………..14 maintenance schedule…………………………………….....15 other questions….……………………………………………..16 general information/tech support……………………..16 getting to know your x-treme xg-470 page6.

  • Page 7

    Package contents your x-treme xg-470 comes with the following items in the box. Please locate all of the following: 1. The x-treme xg-470 gas scooter 2. Seat/seat posts (2) and clamps (2) 3. Trunk & trunk rack & mounting hardware 4. Battery charger page7.

  • Page 8

    5. Fuel tank and lines 6. Tool kit 7. Gas/oil mixing bottle 8. 10amp fuse 9. Handlebar clamp 10. User manual getting started please read and understand these instructions and the operating procedures section, prior to starting or riding your xg-470 fig. 1 fig. 2 fig.3 fig. 4 page8 assembly 1. Carefu...

  • Page 9

    Fig. 5 fig. 6 fig. 6a fig. 7 fig. 7a fueling this is a two-stroke engine. Page9 5. Install the enclosed rear fender bolts to secure the fender to the frame. There will be one for the rear of the fender, and two for the front. 6. Next, install the fuel tank and fuel lines. (fig. 5) first run the fuel...

  • Page 10

    Only run the engine using a mixture of gasoline and 2-cycle engine oil. Please read operating procedures before fueling! 1. Mix fuel (minimum 90 octane) and 2-cycle engine oil in separate container. Use tanaka perfect mix or a quality 32:1 2-cycle oil. Make sure the fuel is well mixed by shaking the...

  • Page 11

    Operating procedures starting  push the primer bulb 3-5 times to ensure gas it reaching the carburetor. Set the choke lever to the closed (up) position.  pull the recoil starter handle briskly, making sure to keep the handle in your grasp, and not allowing it to snap back. Once the engine is runni...

  • Page 12

    Warning! Never start the engine without the complete clutch cover assembled! Otherwise the clutch can come loose and cause personal injuries. In the carburetor, fuel is mixed with air. When the engine is tested at the factory, the carburetor is basically adjusted. Further adjustment may be required ...

  • Page 13

    Cleaning the air filter it is a good idea to occasionally clean the air filter to insure optimum performance. Braking system page13 to clean the air filter: 1. Using a philips head screwdriver, remove the carburetor cover by turning the cover screw counter-clockwise. (fig.10). 2. Remove and clean th...

  • Page 14

    The xg-470 uses both front wheel and rear wheel hub brake systems activated by hand levers (on either side of the handlebar). Squeezing the brake lever with your left hand activates the rear brake, and squeezing the brake lever with your right hand activates the front brake. Make sure to release the...

  • Page 15

    Squeaky brakes the brakes may squeak until they are broken in. This is normal and will not affect the function or performance of the brakes. With continued use the squeak should go away. Tire and wheels tire pressure the tire must be inflated to a maximum of 50 p.S.I. It is also recommended to use a...

  • Page 16

    Adjusting the chain the chain will come adjusted from the factory. However, it may be necessary to adjust the sprockets from time to time. The chain must be well aligned onto the sprockets in order to avoid uneven wear. This will result in shortened chain life. How tight should the chain be?  if th...

  • Page 17: Tremescooters.Com

    Maintenance schedule proper care of your x-treme xg-470 will insure optimal performance and longer life span. The following are a few maintenance suggestions that will keep your x-treme xg-470 running in top condition: daily maintenance perform each time you ride your xg-470  clean the exterior of ...