X-TREME XG-550 Owner's Manual - page 7
Page7
PACKAGE CONTENTS
Your X-Treme XG-550 comes with the following items in the box. Please locate
all of the following:
1.
X-Treme XG-550 Gas Scooter
2.
Tool Kit
3.
Product Handbook
4.
10amp Fuse
5.
Tire Tube Air Extension Valve (may be inside tool kit)
6.
12V Charger
GETTING STARTED
Please read and understand these instructions and the OPERATING
PROCEDURES section, prior to starting or riding your Scooter
Fuse Installation
Your scooter comes with 10amp fuse that is NOT installed at the factory.
Follow the instructions below to properly install the fuse before attempting to use your
scooter.
1. Locate the 10-amp glass fuse that came with your scooter.
2. Locate the fuse holder on the right side of the scooter frame under the footplate.
3. Remove the fuse holder cap and insert the fuse into the cap first.
Then insert fuse/cap into fuse holder and gently tighten. DO NOT OVER TIGHTEN
THE CAP.
Unfolding
1. Carefully remove the XG-550 from the box.
2. To unfold the XG-550, begin by pressing
down on the FOLDING HANDLE with one
hand (Fig.1), while gently pulling up on the
handlebars with the other (Fig.2)
3. Fully extend the handlebars to their upright
position until you feel the mechanism lock
into place (Fig.3)
4. When you first take the XG-550 out of the
box, the left and right hand brakes are in
the down position for shipping. Using the
provided Allen Wrench, loosen the tension
bolt, and adjust the hand brake levers to a
comfortable position (Fig.4). *BE CAREFUL
NOT TO PULL ON THE CABLES!