X-TREME XG-565 A-Blaze Signature Series Owner's Manual - Package Contents
6
PACKAGE CONTENTS
Your X-Treme™ A-Blaze Signature Series XG-565 Gas Scooter comes with the following
items in the box:
Please locate all of the following:
1. The XG-565 Gas Scooter
2. Allen Wrench
3. Owner’s Manual
GETTING STARTED
Please read and understand these instructions and the OPERATING PROCEDURES section
prior to starting or riding your XG-565!
Unfolding
1.) Carefully remove the XG-565 from the box.
2.) To unfold the XG-565, begin by pressing down on the FOLDING HANDLE with one
hand, (Fig. 1) while gently pulling up on the handlebar post with the other (Fig. 2).
3.) Fully extend the handlebar post to the upright position until
you feel the mechanism lock into place (Fig. 3).
4.) Detach the handlebar from the post and mount the handlebar
on to the post using the 4 bolts provided. Ensure the
handlebars are in the center.
5.) Adjust the Gas and Brake Levers using the provided Allen
Wrench, loosen the tension bolt and adjust the levers to a
comfortable position (Fig. 4 next page).
**BE CAREFUL NOT TO PULL ON THE CABLES!!!
Fueling
This is a 2-stroke engine. Always run the engine using fuel
mixed with 2-cycle engine oil.
PLEASE READ OPERATING PROCEDURES BEFORE FUELING!!
6.) Mix fuel (unleaded) and 2-cycle engine oil in separate
container. Use between 40:1 and 60:1 oil mixture ration
depending on the quality of fuel in your area. (Refer to Fuel Guide
on page 9). Make sure the fuel is well mixed by shaking the
container.
7.) Make sure that the engine is off!