X-TREME XMB-420 Manual - Important!

Manual is about: Electric Mobility Scooter

Summary of XMB-420

  • Page 1

    1 x-treme™ electric scooters xmb-420 electric mobility scooter read this manual completely before riding..

  • Page 2: Important!

    2 battery maintenance and charging instructions 1. You must charge completely prior to initial use. (follow charging instructions in your product handbook) 2. Charge immediately after each use. 3. Charge before storage. You must charge every 30 days if not in use. 4. Charge the unit for 6-8 hours or...

  • Page 3: Important

    3 warning this product does not conform to federal motor vehicle standards and is not intended for operation on public streets, roads or highways. Serious injury can result from the unsafe operations of this product. Operator can minimize these risks by using certain safety equipment such as: safety...

  • Page 4: Quick Reference

    4 safety guide the recommended minimum age for riding this scooter is 16 years old. To avoid damage to the motor and footplate, do not overload the scooter. Never ride with more than one person. Inspect your scooter thoroughly before each use for loose or missing parts. Avoid unintentional starts by...

  • Page 5: Do Not Return To Store!

    5 do not return to store! Do not use this vehicle for the first time until you have inflated the tires to the correct psi and completely charged the battery. Failure to follow these instructions may damage your vehicle and void your warranty. If you need help call or go online 1-253-777-0690 www.X-t...

  • Page 6

    6 table of contents important information……………………………………………………. 2-3 quick reference safety guide……………………………………………. 4 table of contents…………………………………………………………. 6 riding safety……………………………………………………………… 7-9 safety basics: do’s & don’ts……………………………………….. 7-8 operating reminders and suggestions………………………………. ...

  • Page 7

    7 riding safety this is not your typical mobility scooter! **this is a fast and powerful scooter that is capable of bringing the front wheel up and off the ground if not careful. Having the seat slid completely back as well as the speed set to high increases its ability to “pop a wheelie” when the t...

  • Page 8

    8 o never hitch a ride by holding on to another vehicle. O never ride your xmb-420 while under the influence of alcohol or other drugs. O if possible, avoid riding in bad weather, when visibility is obscured, at dusk or in the dark, or when you are very tired. Each of these conditions increases the ...

  • Page 9

    9 potholes and slippery surfaces such as lane markings and train tracks all become more hazardous when wet. Night riding a rider is very difficult for motorists to see at dusk, at night, or at other times of poor visibility. If you must ride under these conditions, check and be sure you comply with ...

  • Page 10

    10 specifications battery voltage 24volt dc,20ah motor wattage 400w wheel size 16”*2.6 top speed 15km/h charging time 4-8h distance of full charge 50km grade ability 15° max rider weight 150kgs left and right indicators yes rear view mirrors yes.

  • Page 11

    11 getting to know your xmb-420 1. Battery storage access (tilt seat forward) – (4) 12v24ah batteries total 2. Seat recline adjuster 3. Drop-down arm rests 4. Forward/reverse switch 5. Instrument panel 6. Throttle 7. Brake lever 8. Ignition switch figure 1 on/off power switch position 1 – power off ...

  • Page 12

    12 figure 2 hi/low speed switch position 1 – low speed position 2 – hi speed figure 3 when you are seated on your scooter, you will see these switches on the right side of the handlebars. A. Light switch position 1 – lights off position 2 – turn on speedometer and tail light position 3 – turn on hea...

  • Page 13

    13 figure 5 figure 6 the circuit breaker switch (figure 6) can be located underneath the seat in the seat barrel compartment (figure 5). While the operating current exceeds the rated current, the circuit breaker would cut the current, but with this circuit breaker switch you can reconnect the curren...

  • Page 14

    14 assembly and setup 1) with the cardboard, steel frame top & sides, and packing material removed you are ready to begin assembly. The tools needed for setup are included in the xmb-420 tool kit (located in the compartment under the seat). 2) attach the front wheel: a. Remove the axel bolt from the...

  • Page 15

    15 routine operation pre-ride check 1) be sure the tires 35 psi air pressure. A low tire pressure risk rim pinching (tube failure), lowers your range (distance per charge) and may damage the differential. 2) be sure the battery is fully charged. Riding on a low state-of-charge will reduce range, and...

  • Page 16

    16 battery care and maintenance what to expect of your batteries, ideally the battery is a sealed lead-acid type, with a gel electrolyte. With normal use, it can last for well over 300 charge/discharge cycles. Know that normal use should mean partial, and not complete discharging. If you employ “sha...

  • Page 17

    17 the affected area with water. If you must handle the battery, wear disposable gloves. Replace the battery if there are leaks, visible breaks or cracks. Dispose of used batteries by taking them to a recycling center, or according to state and local laws. Battery temperature sensitivity ambient tem...

  • Page 18

    18 3) keep the charger and battery away from water to prevent electrical shock and shorting. The charger is intended for use in a covered dry area only. 4) plug the end of the charger’s cord into the socket of the adaptor first. Next connect the adaptor to the xmb-420 (the charger port in located be...

  • Page 19

    19 other maintenance your xb-420m should be checked once a year for a thorough inspection and adjustment. This can guarantee the comfort, safety and the normal operating life of the xmb-420. Front and rear brakes the adjustment of the front brake is the same as in a common motorcycle. It is very imp...

  • Page 20

    20 scheduled maintenance xmb-420 should be checked from time to time. Refer to the maintenance schedule in the following chart: check ● adjust ◆ change ▲ lubricate ■ parts daily 30 days 180 days bolts, nuts, screws, etc-to ensure that nothing is loose. ● ● ◆ ● ■ footboard-to ensure it is not worn ou...

  • Page 21

    21 troubleshooting guide problem cause solution battery gauge does not register anything when vehicle is on. 1. Loose connection near the power switch or battery pack. 2. Battery is completely discharged. 1. Check the connections, reconnecting any that are loose. 2. Charge the battery. Battery gauge...

  • Page 22: Do Not Return To Store!

    22 do not return to store! Do not use this vehicle for the first time until you have inflated the tires to the correct psi and completely charged the battery. Failure to follow these instructions may damage your vehicle and void your warranty. If you need help call or go online 1-253-777-0690 www.X-...