Powerhouse motion detector model pr511 owner’s manual.
I n t r o d u c t i o n a quick look at your motion detector your x-10 powerhouse tm motion detector gives your home a “lived-in” look when you are away, the built-in infrared sensor automatically turns on your outdoor lighting whenever it de- tects movement within its sensing range. Your motion det...
Covered area installing the motion detector position the motion detector so that a moving object cuts “across” its beams, not directly towards them. Motion path motion path (poor detection) (good detection) motion path (good detection) sensor position (good location) nominal zonal coverage (plan vie...
Assembling the motion detector installing the motion detector 1. Screw the base of each lamp holder into the outer holes of the mounting plate. 4. Lock the sensor head into place using the locking ring. You can install the motion detector in a wall box that is powered all the time or in a wall box t...
Adjusting your motion detector operation settings this procedure adjusts the aim of your motion detector’s sensor head and floodlights for best coverage. For now. Simply set the controls as instructed. For a detailed description of each control’s function refer to the next section. Before you turn o...
Controlling your motion detector you can use any x-10 controller to turn your motion detector on and off. Set the house code and start code dials, then follow your controller’s in- structions to control this light. Note: if you turn the floodlights on us- ing a controller, they will stay on until yo...
This is x-10 powerhouse mini timer (mt522) instantly controls up to eight x-10 mod- ules and programs up to four modules to turn on and off at specific times. Can turn lights on at random times for added security. Dims lights too! Home automation interface (cp290) set up from an ibm, mac, apple iie/...
Troubleshooting if the floodlights do not turn on. Be sure that the motion detector has power. Check that the wall switch (ii in- stalled) is turned on. Confirm the position of the this unit switch. Check the setting of the dusk control. Note: if you change the dusk control’s setting you must wait 1...
Important notes if the floodlights connected to your motion detector light control turn on but do not turn off, follow these steps: 1. Set range control to max. 2. Set dusk control to light. 3. Set time delay to 0.1. 4. Set this unit switch to sensor. 5. Turn off the power at the circuit breaker pan...
