X10 RVK35 Owner's Manual - page 7
1 3
1 2
F
INE
T
UNING
YOUR
V
IDEO
S
ENDER
The Wireless Video Sender usually works best with the flat faces of the
antennas on the Sender and Receiver unit facing each other (i.e. in “Line of
sight” - see diagram below). Sometimes, however, reflections and other
effects in the home may affect the signal so that some adjustment of either
the Sender or Receiver antenna may be necessary to get the best the signal.
I
F
YOU
ARE
NOT
GETTING
ANY
SIGNAL
AT
ALL
Check that the CHANNEL slide switch (labeled 1 to 4) on both units (on
bottom) is set to the same number.
If you are using coaxial TV connections from the Video Receiver, check that
the TV is tuned to the same channel as the TV Channel switch on the
bottom of the Video Receiver (3 or 4).
I
F
THE
SIGNAL
IS
POOR
,
OR
THERE
IS
INTERFERENCE
Try changing the channel on both units. Do this by adjusting the CHANNEL
slide switch on the bottom of each Video Sender unit to any position from
1-4. Make sure both units are set to the same channel.
I
F
YOU
WANT
TO
USE
YOUR
V
IDEO
S
ENDER
TO
TRANSMIT
FROM
YOUR
S
TEREO
S
YSTEM
ONLY
Just hook up the Video Sender using only the red and white jacks for the
right and left channels of the audio signal.
Leave the yellow (video) jacks
unconnected.
I
F
YOUR
SECOND
TV
IS
ALREADY
HOOKED
UP
TO
A
DSS R
ECEIVER
OR
OTHER
A/V
DEVICE
If your DSS Receiver or other A/V
component is connected to the TV using
A/V cables, you can connect the Video
Receiver to the free LINE IN jacks on the
component. If there are no LINE IN jacks,
you will need to use a TV antenna splitter
as described earlier.