Owner's manual indoor/outdoor color camera with built-in 2.4 ghz wireless transmitter, plus x10 controlled power supply, and video receiver. M odel vk69a ( includes xc18a c amera , xm13a addressable power supply , and vr36a v ideo r eceiver ) xc18a xm13a vr36a.
3 33 33 2 22 22 c ontents c ontrols and c onnections ........................................................ 4 v ideo r eceiver .............................................................................. 4 c amera .....................................................................................
5 55 55 4 44 44 plug power supply in here. Important: unplug power supply before unplugging power jack. Plug into any ac outlet set codes wheels. Point the raised dimple on the antenna towards the receiver’s location. Attach to a wall. Cable adapter. Outdoors indoors set channel switch (under rubber...
7 77 77 6 66 66 s etting up the c amera , and r emote c ontrolled p ower s upply referring to the diagrams below and on the previous page: 1. Attach the camera to a wall using the screws provided. 2. If you install the camera outdoors, make a small hole in your exterior wall and pass the low voltage...
9 99 99 8 88 88 c amera v ideo r eceiver pip f ine t uning your s ystem the system usually works best with the "pip" on the camera's antenna facing the flat side of the receiver's antenna (see diagram below). Sometimes, however, reflections and other effects in the home may affect the signal so that...
11 11 11 11 11 10 10 10 10 10 in most cases, relocating the camera or receiver a few feet is enough to avoid the source of interference. Try unplugging/turning off any electromagnetic interference producing devices, such as a microwave oven, baby monitor, computer, wireless lan, wireless speakers, c...
Vk69a-09/01 x10.Com, a division of x10 wireless technology, inc. (returns depot), 3824 north 5th st., suite c, north las vegas, nv 89032 www.X10.Com.
