X10 VK72A Owner's Manual - page 6
11
10
I
F
YOUR
SECOND
TV
IS
ALREADY
HOOKED
UP
TO
A
DBS R
ECEIVER
OR
OTHER
A/V
DEVICE
If your DBS Receiver or other A/V
component is connected to the TV using
A/V cables, you can connect the Video
Receiver to the free LINE IN jacks on
the component. If there are no LINE IN
jacks, you will need to use a TV
antenna splitter as described earlier.
H
OOKING
UP
THE
A
UDIO
R
ECEIVER
1. Connect a set of Audio/Video cables to the A/V OUT jacks of
the Video Receiver. Connect the other end to your TV.
2. Plug the Video Receiver's Power Supply (the smaller of the two
power supplies) into a 120 volt wall outlet and plug its jack
into the Video Receiver.
3. Position the Video Receiver in a convenient location such as on
top of the TV and orient the antenna so that the flat side points
in the direction of the room where you set up the Video Sender.
I
F
YOUR
TV
DOES
NOT
HAVE
A/V
CONNECTORS
You can use the supplied
coaxial cable to connect the
TV OUT socket on the Video
Receiver to the Antenna
input on your TV. If you
already have an antenna
connected to your TV, you
will need to use a TV
antenna splitter.
Set your TV and the TV
Channel switch on the
Video Receiver (on bottom)
to the same channel (3 or 4).