X4-Life Video Ski Goggles HD1 User Manual - 9.1. Charging The Goggles
9.1. Charging the goggles
Please charge the battery fully when first unpacking and using
the goggles. To charge the battery, remove the cover of the
USB socket (5). Please use the supplied USB cable and the sup-
plied power supply or a computer by inserting the USB cable
into the USB socket (5) in the goggles and connect it to the po-
wer source. Charge the battery for a minimum of four hours.
During charging session the blue LED, situated in the top right
hand corner on the inside of the goggles, will continuously
blink. The LED will stop blinking and go permanently on when
the charging cycle is completed.
Advice on the lifetime of batteries:
It is advisable to let the battery go fully flat from time to
time and then recharge it again fully for several hours. This
refreshes the battery.
10. Camera functions
10.1. The SD- Card
To be able to record the pictures from a camera Micro SD-card
is needed. The card can have a capacity of up to 32 GB. If it
is not formatted, it can be preformatted on your Notebook
or PC. It should be formatted in FAT 32. 1 GB corresponds to
approximately 15 minutes of recording time with the default
presets.
Note: it is recommended to use a fast Micro SD-card (mini-
mum class 10). Slip the SD-card into the slot next to the USB
connector (5). The contacts should be facing the USB connec-
tor. Press the card down until it automatically clicks in.
Note: if there is a problem with the format of the Micro SD-
card, in the LED in the top right hand corner on the inside of
the glasses will blink rapidly for approximately 20 seconds and
20