Xantech 282X Installation Instructions
MODEL
282X
‘NAKED’ [No Shell] EMITTER
INSTALLATION INSTRUCTIONS
DESCRIPTION
The 282X is Xantech’s Mouse Emitter without the Mouse! That’s
right, an emitter without the shell! This emitter is for those jobs
where you need that clean & natural look with no emitter stuck to
the front of the device and no wire hanging above or below the
DVD Player, Home Theater Receiver or other.
This emitter can be placed
inside
the device attached near the units
internal IR Sensor with the emitter wire dressed neatly out the rear
for a perfectly clean IR Control System.
Model 282X
‘Naked’ [No Shell] Emitter
Fig. 1
INSTALLATION
ATTACHING THE EMIITER TO THE INSIDE OF THE IR
CONTROLLED DEVICE
•
Disconnect the IR controlled device from the AC power
source.
•
Remove the top cover of the device.
Note:
Consult the device manufacturer’s instruction
manual for possible Warranty issues.
•
Locate the devices internal IR Sensor along the front
panel.
•
In cases where it is difficult to find the IR sensor, consult
the device’s owner’s manual or locate the IR sensor via
the front panel, using a flashlight to see through the front
window. If all else fails, simply place the 282X emitter in
different locations and see where the most reliable control
is achieved.
•
Adhere the 282X emitter close to the sensor (or best
location) using hot glue or other adhesive. See Figure 2.
KEEP HOT GLUE OFF OF EMITTER LENS.
3.5MM MONO
MINI PLUG
(+)
(-)
NOTE: WHITE STRIPED SIDE IS POSITIVE
TOP VIEW
5/8
3 FT
7 FT