Xantech 789-44 Installation Instructions

1

Modules & Connecting Blocks

INSTALLATION INSTRUCTIONS

12VDC

+12

 VDC

GND

ST

A

TUS

IR IN

EMITTERS

789-44

CONNECTING BLOCK

®

IR

RCVR

Fig. 1

 Model 789-44 Connecting Block

The Model 789-44 provides a quick low cost means of connecting

Xantech IR receivers and keypads to four single or four dual

emitters, with a power supply, in an infrared repeater system.  It

can also provide emitter expansion for various Xantech devices,

such as the 590, 710, 792-10, 795-20, 796-20, etc.. The STATUS

terminal provides a convenient tie point for voltage to drive the

STATUS indicator on certain Xantech products, such as the 780-

80 IR Receiver (refer to Fig. 3).

SPECIFICATIONS

• Inputs: 1 - Screw type 4-terminal plug-in.  1 - IR Receiver "IR RCVR" 3.5mm stereo mini jack.  (See Caution

Note, Fig. 4)

• Outputs: 4 - Emitter ports (3.5mm mono mini jacks) parallel driven.

• Contains a 470 Ohm resistor in series with each emitter output.

• Xantech 282, 283, 284 & 286 Mini Emitters may be used.

• Power requirements: 12 volts DC. Uses 781RG or 782-00 Power Supplies.  Note: A power supply is not

connected to the 789-44 when it is used as an emitter expander.

• 2.1 mm coaxial power jack.

• Dimensions: 2-15/16" W  x 1-3/4" D x 13/16" H

INSTALLATION

Fig. 2, illustrates a typical installation using the 789-44 in an IR repeater system. A variety of Xantech IR

receivers and a keypad are shown.  When configuring a system, please keep the following items in mind:

1. More IR receivers may be wired in parallel, in the same manner as shown, up to a maximum of twelve.

More than twelve is not recommended since IR noise picked up by the many IR receivers may cause

erratic operation and reduce remote control range.

Note: This restriction does not apply to Xantech SmartPad keypads.  These may be added virtually

without limit, provided power supply requirements are taken into consideration.  See item 3.

2. Be sure to connect the +12V, IR OUT and GND of each IR Receiver and keypad to the respective

+12VDC, IR IN and GND of the connecting block as shown.

3. Xantech SmartPads may be used by themselves or together with IR receivers as shown.  When you

do this however, the higher current requirements of the keypads must be taken into consideration as

follows:

a) Each 730-00 keypad draws 65 mA. A SmartPad

2 or 3

 draws 85ma.

b) Each IR receiver draws 10 to 20 mA (check specs. on actual model).

c) The max. current for proper operation from the 781RG Power Supply is 200 mA.

d) The max. current from the 782-00 Power Supply is 1000 mA.

e) When using combinations of keypads and receivers, do not exceed the max. current of the

     power supplies as noted above.

789-44

CONNECTING BLOCK