Xantech CC62 Installation Instructions
1
Remote Control Switchers
INSTALLATION INSTRUCTIONS
CC62
REMOTE RELAY MODULE
Fig. 1
The Model CC62 Remote Relay Module
NO
NC
NO
NC
NO
NC
NO
NC
NO
NC
NO
NC
NO
NC
NO
NC
NO
NC
NO
NC
NO
NC
NO
NC
RELAY
1
RELAY
2
RELAY
3
RELAY
4
RELAY
5
RELAY
6
CC62
REMOTE RELAY MODULE
IR CONFIRM
12 VDC
1A
+12V
GND
GND
IR IN
The CC62 Remote Relay Module consists of six double-pole double-throw relays which are controlled by
way of IR commands from a Xantech RC68+ (or RC68) Programmer. The RC68+ commands are "taught"
to learning devices and passed to the CC62 IR IN (S) and G input terminals via Xantech IR receivers,
keypads, etc. The six relays give "dry contact" closures for a multitude of uses where simple contact
closures are needed. Any combination of one to six relays may be selected and operated in several ways
using the commands from the RC68+ Programmer.
FEATURES AND SPECIFICATIONS
• 6 double-pole double-throw relays rated at 5 Amps. 30 volts DC.
• 2 normally open and 2 normally closed contacts per relay.
• Six 6-terminal screw-type plug-in connectors - one for each of the relays.
• Each relay and the relay poles are isolated from each other allowing use in circuits of differing potentials
and grounds.
• 4-terminal IR IN and +12V plug-in for Xantech IR Receivers, Smart Pads, connecting blocks and other
devices.
• IR Confirm LED lights with RC68+ and non RC68+ IR signals.
• RC68+ IR commands permit Pair, Toggle, Momentary and Group mode operations as well as different
IR codes for use of multiple CC62's.
• The CC62's Code Group number is 60.
• Universal mounting fits 19-inch racks or any 3-1/2" X 19" flat surface. Extends about 2-3/4" behind panel
with cables connected.
• Requires RC68+ (or RC68) Programmer and 782-00 Power Supply.
• Power: 12 VDC @ 300mA.
• Dimensions: 19" W x 3-1/2" H x 2-1/4" D
RC68+ PROGRAMMER / REMOTE CONTROL
The RC68+ Programmer (available separately) contains all commands necessary to operate the CC62 (see
Fig. 2).
• You will need it to program universal learning devices such as the Xantech URC-1 learning remote, the
Xantech Smart Pads, the 590 Controller, the 710 Fone Link, etc., with commands that operate the CC62.