Xantech DL25 Installation Instructions
INSTALLATION INSTRUCTIONS
DL95
Dinky Link™ Surface Mount
Extended Range
Plasma\LCD\LED\CFL Friendly
IR Receiver
1
DESCRIPTION
These small IR receivers have been designed for mounting in very small
spaces. They may be mounted under shelf edges, cabinet ledges, in wall
speakers, etc. – anywhere an inconspicuous appearance is desired. The high
sensitivity of these receivers allows placement behind speaker grilles and still
receive IR commands up to 120 feet away*.
FEATURES
•
Wire channel for clean installation.
•
System testing red-talk-back LED.
•
Includes 3-Terminal Block for easy extension to remote room locations.
SPECIFICATIONS
•
Infrared carrier frequency bandwidth: 25 - 60 kHz.
•
Reception range: Up to 120 feet.*
•
Reception angle: +/- 60 degrees.
•
Cable requirements: See “INSTALLATION” below.
•
Max. Transmission length: 1 mile using 18 gauge wire.
•
Maximum current output: 100mA.
•
Drives IR emitters through Xantech Connecting Blocks, Controllers, etc.
•
Dimensions: 2.55” x 0.55” x 0.35” (65mm x 14mm x 9mm).
•
Power requirements: +12VDC, 10mA.
* Depending on remote control output strength and ambient conditions.
MOUNTING
The IR receiver can be mounted to any flat surface, using the two-sided
adhesive tape supplied. Two screws are included for mounting the 3-terminal
block provided with the IR receiver.
An additional feature is a wire channel on the rear of the surface mount IR
receiver. This will give the installer the ability to provide clean wire dressing in
any direction.