1. DL manuals
  2. Xantech
  3. Remote Control
  4. MAC1
  5. Installation Instructions Manual

Xantech MAC1 Installation Instructions Manual

Manual is about: Mini Macronizer

Summary of MAC1

  • Page 1

    Installation instructions model mac1 mini-macronizer™ table of contents section title page introduction ........................................................................................................................................................3 computer requirements .......................

  • Page 2

    Page 2 model mac1 © 2002 xantech corporation 12v dc ir output reset pc com port serial port 1 (db9, male) pcir-1 (rear panel) computer (typical rear panel of a laptop computer) xantech com port 291-10 ir receiver (optional - see text) to 120 v ac (unswitched) 781rg power supply (included) satellite ...

  • Page 3

    Model mac1 page 3 © 2002 xantech corporation introduction the mac1 mini macronizer has the ability to send ir codes or sequences when triggered by a single rc68+ command. The first section of this manual will cover aspects of drag460 regarding setup, learning ir codes etc. The following sections wil...

  • Page 4

    Page 4 model mac1 © 2002 xantech corporation serial port selection when first launched, the dragon drop-ir software scans the serial ports and will display the available ports under "preferences" in the file menu. Unavailable ports will be grayed out. Com port 1 would normally be used, but if it is ...

  • Page 5

    Model mac1 page 5 © 2002 xantech corporation note: if you wait longer than ten seconds, a “no ir recorded” message will appear. Click “ok” and try again. 9. Repeat steps 6 thru 9 for all of the functions to used for that component. 10. With the pcir connected to the connecting block as shown in fig ...

  • Page 6

    Page 6 model mac1 © 2002 xantech corporation getting source commands from the internet xantech.Com there are some ir commands that can be difficult to learn in dragon. Xantech edits and posts some of these commands at xantech.Com under products/ir code libraries. (see website for listings and downlo...

  • Page 7

    Model mac1 page 7 © 2002 xantech corporation figure 5 – mac1 base unit rc68+ code group 1. The default code group for rc68+ codes for the mac1 is “80” 2. Click the “options” button on the mac1 window to confirm code group setting (figure 6). Note: the information in the base options window is for re...

  • Page 8

    Page 8 model mac1 © 2002 xantech corporation 3. Changing the code group will allow additional control of ir code sequences and rc68+ commands. I.E. Having one mac1 set to code group “80” and another set to code group “90”. 4. When changing code groups, be sure the new setting is not a default settin...

  • Page 9

    Model mac1 page 9 © 2002 xantech corporation editing sequences 1. The command list can be edited by dragging and dropping any command on the list to any position on the list. Left click and drag the command to be moved. As you drag upward and you want the command between two existing commands, drop ...

  • Page 10

    Page 10 model mac1 © 2002 xantech corporation saving and backing-up files automatic save when working on a project in dragon, it is automatically saved on a continuous basis, it is ok to quit a project at any time and come back to it for further work by simply clicking on open project (ctrl+o) from ...

  • Page 11

    Model mac1 page 11 © 2002 xantech corporation.

  • Page 12

    Xantech corporation 12950 bradley avenue, sylmar ca 91342-3829 phone 818.362.0353 • fax 818.362.9506 www.Xantech.Com part no. 08901135 rev a 01-31-2002.