Summary of MRKP1E
Page 1
Installation instructions mrkp1e keypad controller eu and uk standard.
Page 2
1 safety information read information — all the safety and operating information should be read before the appliance is operated. Follow information — all operating and use information should be followed. Retain information — the safety and operating information should be retained for future referen...
Page 3
21 2 safety check — upon completion of any service or repairs to this audio product, ask the service technician to perform safety checks to determine that the audio product is in proper operating condition. Lightning storms — unplug this apparatus during lightning storms or when unused for long peri...
Page 4
3 • do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. • in the unlikely event that smoke, abnormal noise, or strange odor is present, immediately power the mrkp1e off. Please report the problem to your dealer ...
Page 5
19 5. Troubleshooting symptom possible cause solution mrkp1e does not power up 1. Rj-45 plug crimped incorrectly; or wiring pin-out of rj-45 reversed. Verify wiring pin-out and rj-45 crimp. Correct by re-crimping rj-45 to cat-5 cable. 2. Break in cat-5 between zone and “head-end”. Check rj-45 to rj-...
Page 6
5 defining terms zone a zone is defined as an area of the house that has separate source selection capabilities from all other areas of the house. Typically, a zone is comprised of a single room, but it is possible for a zone to spread across multiple rooms (kitchen/dining room, master bedroom/maste...
Page 7
17 fig. 4.1 main setup menu diagram (continued on next page) ( mrc88m/mraudio8x8m require firmware ver. 2.03 or later to work with the mrkp1e) continued on the next page 6 2.0 system design overview/applications notes: a recommended electrical back box is always required for all installation of this...
Page 8
7 pre-wiring cat-5 wiring between mrc88m and mrkp1e the mrc88m and all associated components are wired using cat-5 terminated to the t568a or t568b wiring standard (figure 2.1). When pre- wiring the system, run lengths of cat-5 from the pre-determined mrc88m location to each keypad or touch panel lo...
Page 9
15 setup button x button 4. Mrkp1e main setup menu to access the main setup menu, 1. Press and hold down the “x” key for at least 3 seconds. 2. Once the main setup menu is displayed on the screen, use the “source ” and “source >” buttons to highlight the category to be changed. 3. Press the “x” butt...
Page 10
9 mrkp1e – rear connectors figure 2.3: rear connector board of mrkp1e keypad item description 1 expansion rj-45 port 2 controller rj-45 port 3 external ir input terminal 4 rs485 termination 5 ir emitter output 6 internal ir sensor enable/disable jumper (remove to disable) 3 1 2 5 6 4 expansion contr...
Page 11
13 internal ir receiver the internal ir receiver is located beneath the center of the keypad’s face plate. The internal ir receiver receives ir commands for the mrkp1e and for the mrc88m. It will also pass-thru ir remote control commands to audio sources, via an emitter, to each of the sources conne...
Page 12
11 note: do not mount the mrkp1e in the same electrical back- box as high voltage devices such as electrical outlets or switches. Figure 2.5: mrkp1e keypad installation (see specifications) 12 3. Connections mrkp1e to mrc88m and expansion keypads each rj-45 connector under each preamp out (1 – 8) is...