Xantech MRWC Install Manual - page 3
08905148A
-
3
-
INSTALLATION – CHANGING IP ADDRESS and HOST NAME
STEP (A)
Connect the Serial 1 Port of the MRWC to your computer with an RS-232 Data Transfer Cable (also
known as a Null Modem Cable).
Using Hyper Terminal (or similar software), connect to the MRWC with the default Serial Settings:
Baud Rate: 9600, Data bits: 8, Parity: None, Stop bits: 1, Flow control: None
STEP (B)
Press & hold the reset button for 5 seconds. The MRWIC Boot Menu will appear on the terminal
screen:
MRWC Boot Menu
------------------------------
0 : Display Current Settings
1 : Restore Factory Defaults
2 : Configure IP Settings
3 : Set Password
4 : Set Host Name
5 : Download New Firmware
6 : Lamp Test
7 : Hardware Test
8 : Erase All Files
9 : OEM Functions
x : Exit menu and boot
Selection:
Press 2: Configure IP Settings
Use to enable DHCP or manually set an IP address, subnet mask, and gateway IP address.
Press 4: Set Host Name
The maximum length is 16 characters, numbers and letters only.
Xantech Corporation
13100 Telfair Avenue, 2/F
Sylmar, CA 91342
Installation Instructions, MRWC
© 2008 Xantech Corporation, Document #08905148A
This document is copyright protected. No part of this manual may be copied or reproduced in any form without prior written consent from Xantech
Corporation.
Xantech Corporation shall not be liable for operational, technical, or editorial errors/omissions made in this document.