08905084d - 1 - installation instructions xtr39 & rf2ir.
08905084d - 2 - introduction this document is an addendum to the xtr39 manual. Here you will learn how to setup the xtr39 to communicate with the rf2ir. The xtr39 will send ir commands embedded in an rf signal and send it to the rf2ir. At the rf2ir, the ir command will be emitted to the installed so...
08905084d - 3 - global properties (convert existing projects to rf projects) existing xtr39 projects can be converted to work with the rf2ir without modifying every command. This can be done selecting the “global ir properties” window. A new “properties” window will appear that applies to all comman...
08905084d - 4 - changing an ir command to a rf command for projects where only certain commands will be sent via rf transmission, please proceed as intended. After an ir command has been placed under a function button, it can be configured to become an rf command. Step 1: in universal dragon under t...
08905084d - 5 - changing an rs232 command to an rf command after an rs232 command has been placed under a function button, it is automatically configured to output on the rs232 port of the rf2ir. No additional configuration is required. After programming the xtr39 is complete, perform a “base unit t...
08905084d - 6 - rf2ir configuration (channel address) the channel address on the rf2ir cannot be programmed using universal dragon. Located on the bottom of the rf2ir device is a rotary switch. Turn this switch to select the desired channel address. The switch is labeled in hex notation. “a” stands ...
08905084d - 7 - update firmware instructions step 1: you will need universal dragon and a null modem cable adapter to perform a firmware update. The rf2ir device needs to be powered. Step 2: connect the rs232 adapter cable and the null modem cable adapter to the computer. Step 3: launch universal dr...
