Xantech RMZPR Installation Instructions

Page of 2

Download

Bookmark us

Amplifiers & Preamplifiers

INSTALLATION INSTRUCTIONS

RMZPR

RACK MOUNT ADAPTER FOR THE ZPR68-10

The RMZPR provides a convenient means for mounting the ZPR68-10 Six Zone Eight Source Remote

Preamp into a standard 19 inch rack. It incorporates six STATUS LED's that indicate zone ON/OFF

condition. The black anodized panel is a standard 8.75 inch increment height and is 3/16" thick. Install the

panel as follows:

1. Mount the ZPR68-10 to the rear of the RMZPR. Refer to

Fig. 2

below. Use the hardware that comes

with the ZPR68-10 and the RMZPR.

2. Plug the 10-lead connector of the ribbon cable into the mating 10-pin connector on the ZPR68-10.

Be sure to orient the connector so that the red stripe on the cable is positioned as shown in

Fig. 2!

NOTE: The LED's will not work with the ZPR68-00.

3. Mount the completed assembly into a 19" rack using the rack panel cup washers and screws supplied.

See Fig. 2 on next page.

Fig. 1 The RMZPR, Front View

ZPR68

SIX ZONE EIGHT SOURCE REMOTE PREAMP

STATUS

1 2 Next › »

Page 1
1 amplifiers & preamplifiers installation instructions rmzpr rack mount adapter for the zpr68-10 the rmzpr provides a convenient means for mounting the zpr68-10 six zone eight source remote preamp into a standard 19 inch rack. It incorporates six status led's that indicate zone on/off condition. The...
Page 2
2 rmzpr red stripe red stripe 10-lead female connector. Plug into mating 10-pin connector on zpr68-10. Be sure to orient the cable with the red stripe as shown! 10-lead ribbon cable pcb for the 6 led's mount the zpr68-10 to the 4 studs on the rear of the rmzpr using hardware included with the zpr68-...