Xantech Smartspeaker s-62 Installation Instructions

Page of 4

Download

Bookmark us

Speakers & Volume Controls

INSTALLATION INSTRUCTIONS

S-62, S-64, S-66

SMARTSPEAKER

INTRODUCTION

The SmartSpeaker™ line consists of three physically interchangeable speaker/baffle assemblies,

installation and finishing hardware. The speaker/baffle assemblies feature a cut-out for the 480 Dinky

Link™ Infrared Receiver. The systems are designed to be mounted in a wooden-studded plasterboard or

“lath and plaster” wall. They can be mounted in most ceilings, however special acoustic treatment may be

required. The addition of the Dinky Link Infrared Receiver adds the dimension of wireless remote control

extension to any installation.

DESCRIPTION

R-61 Rough-in Kit

• The Rough-in Kit consists of a pair of molded rectangular frames, flat perforated “wings” and thread-

cutting screws.

• The Rough-in Kit is mounted to the wooden studs during construction and is installed before the

plasterboard. It is not used in existing construction.

F63 Bezel/Grille

• The molded plastic bezel mounts directly to the wall or ceiling, with or without the Rough-in Kit. It is held

in place by four “dogs” which slip through the rectangular wall cutout and rotate into clamping position

as they are tightened.

• The bezel can be painted to match the mounting surface after it is installed.

• The perforated metal grille should be painted, if desired, before installation.

• The grille should be carefully installed after the speaker/baffle assembly has been mounted. Care should

be taken so that the edges of the grille do not scratch the finished surfaces of the bezel. The grille should

be painted, if desired, before installation.

Page 1
1 speakers & volume controls installation instructions s-62, s-64, s-66 smartspeaker tm introduction the smartspeaker™ line consists of three physically interchangeable speaker/baffle assemblies, installation and finishing hardware. The speaker/baffle assemblies feature a cut-out for the 480 dinky l...
Page 2
2 s-62, s-64 and s-66 speaker systems • each system, consisting of a woofer, a tweeter and a matching crossover network, is mounted on a baffle panel. • the baffle panels for all three systems are sized to mount in the f-63 bezel. Since the sizes are iden- tical and the system is installed only afte...
Page 3
3 speakers & volume controls fig. 2a fig. 2c fig. 2b speakers existing construction • before cutting any holes in the wall, be certain that the center of the opening is approximately centered between the studs, that there are no supports or fire baffles in the area of the hole and that there are no ...
Page 4
4 fig. 2d (a) (b) (c) (d) (e) fig. 3 speakers 3-10-98 • the dinky link has two windows, one near the cable at the bottom and the other near the top. The lens should be centered over the top window. Remove the grille from the bezel. Drill a 3/8" hole in the grille. • a xantech unibit sd-200 step dril...