Xantech ZATRAN Installation Instructions

Page of 4

Download

Bookmark us

INSTALLATION INSTRUCTIONS

ZATRAN

Zone Audio Transceiver

DESCRIPTION

The ZATRAN is a zone audio transceiver that can be used with one audio/video source. When used

with the ZA8REC or ZAREC (not included), the Zone Audio system can transmit line level audio over

CAT5.

Balanced differential line driver circuits ensure noise-free connections from audio sources located up

to 300 feet away! The ZATRAN’s built-in IR interface allows control of the remotely located source,

and works flawlessly with Xantech’s IR distribution components and multi-room controllers.

For additional information, refer to the Installation Instructions found with the ZA8REC and ZAKIT.

SPECIFICATIONS

Input Level: 0 to 2.0Vpp

Frequency Response: ±0.5dB 20Hz to 20kHz

THD+N: 0.01%

IR Input/Output Levels: +12V

IR Bandwidth: 100kHz

Wire Requirements: CAT5, or 4 twisted pair 22AWG

Use in conjunction with ZA8REC or ZAREC (not included)

Page 1
- 1 - installation instructions zatran zone audio transceiver description the zatran is a zone audio transceiver that can be used with one audio/video source. When used with the za8rec or zarec (not included), the zone audio system can transmit line level audio over cat5. Balanced differential line ...
Page 2
- 2 - installation - zarec and a remotely located audio\video component figure 1 shows a typical application where the remotely located source is a dvd player or similar audio/video device. For an audio only application, simply remove the coaxial video between the zarec and zatran as well as the vid...
Page 3
- 3 - installation – za8rec and a remotely located audio component figure 2 shows a typical application where the remotely located source is a cd player or similar audio device. The remotely located source component can be controlled by affixing the 283m mouse emitter (included) onto the ir sensor w...
Page 4
- 4 - installation – za8rec and zatran wiring the connection between the ‘receive’ and ‘send’ devices can be made using a cat5 cable. Figure 3 shows the recommended wire color-coding connection as per the sticker located on the weco screw terminal. “bl” – blue (ir+) “or” – orange (l+) “bl/w” – blue/...