Xantrex PROwatt 600 Owner's Manual

Other manuals for PROwatt 600: Owner's Manual
Manual is about: Xantrex PROwatt 600 Inverter Owner's Guide

Summary of PROwatt 600

  • Page 1

    Owner’s manual.

  • Page 3

    Contents 1.0 introduction ........................................................................ 1 2.0 safety first … before you use xpower 600 ...................... 2 3.0 quick start guide .............................................................. 3 3.1 overview ................................

  • Page 4

    8.0 recharging xpower 600................................................... 18 8.1 general information on batteries and charging .........................................18 8.1.1 charging options .........................................................................18 8.1.2 battery self-discharg...

  • Page 5

    1 xpower600 owner’s manual 1.0 introduction thank you for purchasing xpower600 ™, the 600-watt electronic generator that’s portable and rechargeable. Designed for both indoor and outdoor use, xpower600 can run a wide range of electrical products – from power tools to entertainment equipment, and eve...

  • Page 6

    2 xpower600 owner’s manual 2.0 safety first … before you use xpower600 misuse of xpower600 may result in danger to the user. We urge you to pay special attention to all caution and warning statements. Caution statements identify conditions or practices that may result in damage to xpower600 or to ot...

  • Page 7

    3 xpower600 owner’s manual 3.0 quick start guide 3.1 overview the following basic instructions are intended to provide a brief overview of xpower600’s key features. For complete information, be sure to read this manual fully. Figure 1 below shows xpower600’s key features and accessories. Figure 1 - ...

  • Page 8

    4 xpower600 owner’s manual 3.2 an explanation of power ratings and battery life ac powered products are rated by how much electrical power (in watts) they consume. Xpower600 is capable of generating a maximum of 600 watts (maximum continuous) to power ac products plugged into the ac outlets. As an e...

  • Page 9

    5 xpower600 owner’s manual 3. Because the dc power socket is internally wired direct to xpower600’s battery, extended operation of a 12 volt accessory may result in excessive battery discharge. Important: care must be taken to ensure the battery does not become totally discharged. See section 6.1 fo...

  • Page 10

    6 xpower600 owner’s manual 4.0 indicators, controls and connection points 4.1 ac power panel as shown in figure 2 below, the ac power panel contains the battery status switch, battery level indicator, ac outlets switch, ac power light, fault light, and dual ac outlets. Figure 2 - view of ac power pa...

  • Page 11

    7 xpower600 owner’s manual 4.1.1 battery status switch / battery level indicator the battery level indicator shows the state of charge of xpower600’s battery. Its function is similar to the fuel gauge in a car. When pressing and holding the battery status switch, one or more of the four lights in th...

  • Page 12

    8 xpower600 owner’s manual 4.2 dc power panel as shown in figure 4 below, the dc power panel contains the dc power socket, which provides 12 volts for operating automotive and marine type products. The dc power socket also serves as the input for recharging with either the ac charger or dc charging ...

  • Page 13

    9 xpower600 owner’s manual 4.3 high power 12 volt dc terminals as shown in figure 5 below, the high power dc termnials are wired directly to xpower600’s battery and supply power for jump-starting a vehicle. See section 7.1 for details. These terminals also can be used to connect an external battery,...

  • Page 14

    10 xpower600 owner’s manual 5.0 powering 115 volt ac products 5.1 general information xpower600 is capable of powering most 115 volt ac products and equipment that use 600 watts or less. Its ac output waveform, called a “quasi-sine wave” or “modified sine wave”, is designed to function similarly to ...

  • Page 15

    11 xpower600 owner’s manual 4. As the battery becomes nearly discharged, or “empty”, a low voltage warning will sound. This will give you time to shut down a computer, for example. If this warning is ignored, the inverter will switch off automatically a few minutes later to prevent battery damage. S...

  • Page 16

    12 xpower600 owner’s manual 5.4 interference with electronic equipment 5.4.1 buzzing sound in audio systems some inexpensive stereo systems and “boom-boxes” will emit a buzzing sound from their loudspeakers when operating from the ac output of xpower600. This is because the power supply in the equip...

  • Page 17

    13 xpower600 owner’s manual 5.5 battery operating times below are typical ac products and equipment that may be operated by xpower600 with estimated operating times. See section 9.0 for information about connecting to an external battery to increase operating time. Operating times will vary dependin...

  • Page 18

    14 xpower600 owner’s manual 6.0 powering 12 volt dc accessories 6.1 connecting 12 volt dc accessories xpower600 can operate any accessory that is intended to run from a vehicle’s lighter socket. Simply insert the accessory’s plug into the dc power socket on xpower600’s dc power panel. Xpower600’s dc...

  • Page 19

    15 xpower600 owner’s manual 6.3 battery operating times below are typical dc accessories that may be operated by xpower600 with estimated operating times. Operating times will vary depending on the battery charge level and the specific accessory being operated. 1 represents actual power consumption ...

  • Page 20

    16 xpower600 owner’s manual 7.0 vehicle or boat engine starting assistance 7.1 jump-starting direct to the battery xpower600 may be used to jump-start a 12 volt vehicle or small boat engine using standard jump-start cables available from most auto parts stores. Jump-starting causes very high current...

  • Page 21

    17 xpower600 owner’s manual 8. Take the other end of the jump-start cables and connect the black negative (-) clamp to xpower600’s negative terminal (black). You are now ready to start the engine. 9. If the vehicle fails to crank, disconnect the jump-start cables in reverse order of steps 5-8. Ensur...

  • Page 22

    18 xpower600 owner’s manual 8.0 recharging xpower600 8.1 general information on batteries and charging 8.1.1 charging options these charging options are possible with xpower600: · charging with the fully automatic “plug-in-and-forget” ac charger. · charging from your vehicle as you drive with the dc...

  • Page 23

    19 xpower600 owner’s manual 3. Plug the other end of the ac charger into a standard 115 volt ac receptacle. 4. As xpower600 charges, its recharge indicator will illuminate amber. A typical recharge will take between 8-10 hours. 5. When fully charged, the recharge indicator changes to green and xpowe...

  • Page 24

    20 xpower600 owner’s manual disconnect the dc charging cable at both ends once xpower600 is fully charged or when your vehicle’s motor is not running. Do not leave xpower600 permanently connected to the vehicle’s lighter socket or 12 volt accessory outlet. Caution: while xpower600 is being recharged...

  • Page 25

    21 xpower600 owner’s manual 9.0 connecting to an external battery 9.1 extended operating time much longer battery operating time is possible when connecting xpower600 to a larger external battery. For example, an external 60 amp-hour battery will provide approximately 150% more operating time then x...

  • Page 26

    22 xpower600 owner’s manual 10.0 battery replacement 10.1 general information about battery life the battery used in xpower600 is a high quality, state-of-the-art design that will serve as a reliable power source for years when properly maintained. To maximize battery life it is important to recharg...

  • Page 27

    23 xpower600 owner’s manual 8. Remove personal metal items such as rings, bracelets, necklaces, and watches when working with a lead-acid battery. A lead-acid battery produces a short-circuit current high enough to weld a ring or the like to metal, causing a severe burn. If you do not know how to sa...

  • Page 28

    24 xpower600 owner’s manual 10.3 obtaining a replacement battery replacement batteries are available in many areas from stores that specialize in higher amperage, deep cycle batteries. The following batteries are approved for use with xpower600: if you are not able to find a replacement battery, ple...

  • Page 29

    25 xpower600 owner’s manual 11.0 troubleshooting problem: ac product will not operate, red fault light is on. Problem: run time is less than expected. Problem: measured voltage at ac outlets is too low. Problem: charging light is off when ac charger is connected. E s u a c e l b i s s o p y d e m e ...

  • Page 30

    26 xpower600 owner’s manual 12.0 specifications 12-volt dc section internal battery type sealed lead acid, agm internal battery voltage (nominal) 12 volts dc internal battery capacity 40 amp-hours maximum load current through 12 volt 12 amps dc power socket (continuous) dc power socket circuit break...

  • Page 31

    27 xpower600 owner’s manual 13.0 limited warranty (usa and canada only) and out-of-warranty service information what does this warranty cover? Xantrex manufactures its products from parts and components that are new or equivalent to new, in accordance with industry standard practices. This warranty ...

  • Page 32

    28 xpower600 owner’s manual you must obtain a return material authorization (rma) number from xantrex before returning a product directly to xantrex. Do not return a product to xantrex without first obtaining an rma number. When you contact xantrex to obtain service, be prepared to supply the serial...

  • Page 33

    29 xpower600 owner’s manual 14.0 other products from xantrex xantrex develops, manufactures and markets power electronic products. Our goal is to offer you top quality products that convert and control electric power. We specialize in dc to ac inverters, battery chargers, backup power supplies and o...

  • Page 36

    Www.Xantrex.Com 445-0104-01-01.