- DL manuals
- Xantrex
- Inverter
- PROWATT SW SW 1000
- Owner's Manual
Xantrex PROWATT SW SW 1000 Owner's Manual
Summary of PROWATT SW SW 1000
Page 1
Tm tm sine wave inverter owner’s guide re mo te fa ul t po we r prowatt sw 600 shown. Prowatt sw 600 prowatt sw 1000 prowatt sw 2000 prowatt sw inverter na.Book page 1 tuesday, september 14, 2010 2:29 pm.
Page 2
Prowatt sw inverter na.Book page 2 tuesday, september 14, 2010 2:29 pm.
Page 3
975-0529-01-01 i trademarks xantrex , prowatt , and smart choice for power are trademarks of schneider electric services international sprl, registered in the u.S. And other countries. Other trademarks, registered trademarks, and product names are the property of their respective owners and are used...
Page 4
Ii prowatt sw sine wave inverter owner’s guide about this guide purpose the purpose of this owner’s guide is to provide explanations and procedures for operating, installing, maintaining, and troubleshooting the prowatt™ sw sine wave inverter. Scope the guide provides safety guidelines, as well as i...
Page 5
975-0529-01-01 iii related information you can find more information about xantrex technology usa inc. As well as its products and services at www.Xantrex.Com . Statement of hazard contains statements of avoidance or strict compliance. Failure to follow these instructions can damage the unit and/or ...
Page 6
Iv prowatt sw sine wave inverter owner’s guide important safety instructions important: r ead and save this o wner ’ s g uide for future reference . This chapter contains important safety instructions for the prowatt™ sw sine wave inverter. Before using the prowatt™ sw sine wave inverter, read all i...
Page 7
975-0529-01-01 v precautions when working with batteries notes: 1. Locate the prowatt™ sw sine wave inverter unit away from batteries in a well ventilated compartment. 2. Always have someone within range of your voice or close enough to come to your aid when you work near a lead-acid battery. 3. Alw...
Page 8
975-0529-01-01 vi fcc statement warning this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that might cause unde...
Page 9
Important safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Iii introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...
Page 10
Prowatt sw inverter na.Book page viii tuesday, september 14, 2010 2:29 pm.
Page 11
975-0529-01-01 1 introduction thank you for purchasing the prowatt™ sw sine wave inverter. The prowatt sw inverter is a high quality, true sine wave output inverter. It is designed to operate ac loads as if these loads were operating from grid/utility supplied power in household ac outlets. To get t...
Page 12
2 prowatt sw sine wave inverter owner’s guide introduction ease of use superior features and rugged durability have been combined with ease of use: • the unit is compact, light weight, and easy to install. • you can power loads directly from the dual gfci-protected ac receptacles on the front panel....
Page 13
975-0529-01-01 3 features the following information describes the main features of the prowatt sw inverter. We recommend that you familiarize yourself with these features before installing and operating the unit. Materials list your prowatt sw inverter package includes these items: • prowatt sw inve...
Page 14
4 prowatt sw sine wave inverter owner’s guide features front panel details figure 2 prowatt sw inverter front panel (prowatt sw 600 shown) feature description 1 indicator leds green led indicates that the unit is on and receiving power. When a shutdown occurs due to an error condition the green led ...
Page 15
975-0529-01-01 5 features back panel details figure 3 prowatt sw inverter back panel (prowatt sw 600 shown) feature description 1 positive (+) dc terminal accepts lug or ring connectors appropriate to the cable size being used. See table 1 : voltage drop per foot of dc cable on page 10 for recommend...
Page 16
6 prowatt sw sine wave inverter owner’s guide installation guidelines follow all instructions from this guide and instructions including safety guidelines from the battery manufacturer. Installing battery cables require some electrical knowledge and local electrical codes. Tools and materials • adju...
Page 17
975-0529-01-01 7 installation determine battery capacity battery type and battery size strongly affect the performance of the prowatt sw inverter. Therefore, you need to identify the type of loads your inverter will be powering and how much you will be using them between charges. Once you know how m...
Page 18
8 prowatt sw sine wave inverter owner’s guide installation notes: when planning to install the prowatt sw inverter, be sure that you consider the location and orientation carefully. The inverter may be used in marine applications such as inside boat compartments that are always dry and protected fro...
Page 19
975-0529-01-01 9 installation connect the chassis ground the prowatt sw inverter has a screw terminal labeled chassis gnd on the outside of the rear panel as shown in figure 3, “prowatt sw inverter back panel (prowatt sw 600 shown)” on page 5. Follow the guidelines below to connect the inverter’s ch...
Page 20
10 prowatt sw sine wave inverter owner’s guide installation cabling guidelines follow these guidelines and refer to table 1 : voltage drop per foot of dc cable on page 10 to determine battery cable lengths. • use 4 awg copper (90 ºc insulation rating) as the smallest battery cable size. This will mi...
Page 21
975-0529-01-01 11 installation fuse/circuit breaker sizing guidelines because batteries can produce thousands of amps, you are required to install dc-rated fuses (or circuit breakers) that can safely withstand the short-circuit current batteries can produce. To select the correct fuse type and size:...
Page 22
12 prowatt sw sine wave inverter owner’s guide installation cabling procedure consult the following configurations and determine a match specific to your installation and follow the installation procedure “to connect the battery cables:” that comes next. To connect the battery cables: 1. Make sure t...
Page 23
975-0529-01-01 13 installation 3. Install a dc-rated fuse on the positive battery terminal. Alternatively, install a dc-rated circuit breaker that connects to the positive battery terminal. The fuse (or circuit breaker must have an ampere interrupting capacity (aic) that exceeds the short-circuit cu...
Page 24
14 prowatt sw sine wave inverter owner’s guide installation 7. Attach the connector on the negative cable to the negative battery terminal. Note: this is the last cable connection. You may observe a spark when making this last connection. Note: make a secure connection. Loose connectors cause excess...
Page 25
975-0529-01-01 15 operation turning the inverter on and off the power switch on the inverter’s front panel turns the control circuit in the prowatt sw inverter on and off. To toggle the inverter on and off from its front panel: 1. Press the inverter’s power switch button (for half a second) to turn ...
Page 26
16 prowatt sw sine wave inverter owner’s guide operation to test (or reset) the gfci protection: 1. Press the unit’s power switch to turn the inverter on. 2. Plug a test lamp into the ac outlet. 3. Push the test button. Note: the reset button should pop out and the power should turn off (the lamp sh...
Page 27
975-0529-01-01 17 operation operating limits power output the prowatt sw inverter will deliver the following power continuously, depending on input voltage and ambient temperature. The inverter will deliver more than 10% of its continuous power rating for approximately five minutes. The inverter mus...
Page 28
18 prowatt sw sine wave inverter owner’s guide operation inverter loads the prowatt sw inverter will operate many ac loads within its power rating. However, some appliances and equipment may be difficult to operate. Please see “exceptional loads” below carefully. Usb loads a lot of usb-powered devic...
Page 29
975-0529-01-01 19 troubleshooting troubleshooting reference electrical shock hazard do not dismantle the prowatt sw inverter. It does not contain any user-serviceable parts. Do not attempt to service the unit yourself. Failure to follow these instructions will result in death or serious injury. Cond...
Page 30
20 prowatt sw sine wave inverter owner’s guide troubleshooting e . 1 . 0 . No output voltage. Short circuit very heavy load output circuit overheat check the ac wiring for a short circuit. Remove the load. Turn the unit off. Let the unit cool down, check the fan for any obstructions and clear it, or...
Page 31
975-0529-01-01 21 specifications note: specifications are subject to change without prior notice. Physical and environmental specifications length × width × height • prowatt sw 600 • prowatt sw 1000 • prowatt sw 2000 12.2×8.7×3.5 inch. (31×22×8.9 cm) 14×9×3.5 inch. (35×22×8.5 cm) 13.8×11.8×3.9 inch....
Page 32
22 prowatt sw sine wave inverter owner’s guide warranty and return information warranty what does this warranty cover and how long does it last? This limited warranty is provided by xantrex technology usa inc. ("xantrex") and covers defects in workmanship and materials in your prowatt™ sw sine wave ...
Page 33
975-0529-01-01 23 warranty and return information what proof of purchase is required? In any warranty claim, dated proof of purchase must accompany the product and the product must not have been disassembled or modified without prior written authorization by xantrex. Proof of purchase may be in any ...
Page 34
24 prowatt sw sine wave inverter owner’s guide warranty and return information disclaimer product this limited warranty is the sole and exclusive warranty provided by xantrex in connection with your xantrex product and is, where permitted by law, in lieu of all other warranties, conditions, guarante...
Page 35
975-0529-01-01 25 warranty and return information return material authorization policy for those products that are not being repaired in the field and are being returned to xantrex, before returning a product directly to xantrex you must obtain a return material authorization (rma) number and the co...
Page 36
26 prowatt sw sine wave inverter owner’s guide warranty and return information information about your system as soon as you open your prowatt™ sw sine wave inverter package, record the following information and be sure to keep your proof of purchase. If you need to contact customer service, please r...
Page 37
Prowatt sw inverter na.Book page i tuesday, september 14, 2010 2:29 pm.
Page 38
Xantrex technology usa inc. 1 800 670 0707 tel toll free na 1 800 994 7828 fax toll free na customerservice@xantrex.Com www.Xantrex.Com 975-0529-01-01 printed in china prowatt sw inverter na.Book page ii tuesday, september 14, 2010 2:29 pm.