1. DL manuals
  2. Xantrex
  3. Battery Charger
  4. XPower Charger 2
  5. Owner's Manual

Xantrex XPower Charger 2 Owner's Manual

Summary of XPower Charger 2

  • Page 1

    Xpower charger 2 owner's guide 975-0135-01-01 rev. B printed in china t 1-800-670-0707 (toll free in north america) 1-360-925-5097 (direct) f 1-800-994-7828 (toll free in north america) 1-360-925-5143 (direct) e customerservice@xantrex.Com www.Xantrex.Com by.

  • Page 2: About Xantrex

    By about xantrex xantrex technology inc. Is a world-leading supplier of advanced power electronics and controls with products from 50 watt mobile units to mw utility-scale systems for wind, solar, batteries, fuel cells, microturbines, and backup power applications in both grid-connected and stand-al...

  • Page 3: Trademarks

    Trademarks xpower by xantrex is a trademark of xantrex international. Xantrex is a registered trademark of xantrex international. Other trademarks, registered trademarks, and product names are the property of their respective owners and are used herein for identification purposes only. Notice of cop...

  • Page 4: Contents

    Contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . 1 about the xpower charger 2 . . . . . . . . . 1 about this guide . . . . . . . . . . . . . . . . . . 1 2. Important safety information. . . . . . . 2 warnings and cautions . . . . . . . . . . . . . . 2 personal precautions . . . . ....

  • Page 5: 1 Introduction

    1 1 introduction thank you for purchasing a xantrex xpower charger 2. The xpower charger 2 is part of a family of ultra-compact, light weight and modern power inverters and chargers from xantrex technology. About the xpower charger 2 the 2 amp xpower charger 2 is designed to charge 12 volt rechargea...

  • Page 6: 2 Important Safety

    2 2 important safety information misusing or incorrectly connecting the xpower charger 2 may damage the equipment or create hazardous conditions for users. Read the following safety instructions and pay special attention to all caution and warning statements in the guide. Warnings identify condition...

  • Page 7

    3 1. Do not expose the xpower charger 2 to rain or snow. 2. Use of an attachment not recommended may result in a risk of fire, electric shock, or injury to persons. 3. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting the xpower charger 2. 4. An ext...

  • Page 8

    4 and in good electrical condition; and c) wire size is no. 18 awg (mini- mum) with a maximum length of 50 ft. (15.2 m). 5. Do not operate xpower charger 2 with damaged cord or plug—replace the cord or plug immediately. 6. Do not operate xpower charger 2 if it has received a sharp blow, been dropped...

  • Page 9: Personal Precautions

    5 personal precautions 1. Someone should be within range of your voice or close enough to come to your aid when you work near a lead-acid battery. 2. Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing, or eyes. 3. Wear complete eye protection and clothing protect...

  • Page 10

    6 with running cold water for at least 10 minutes and get medical attention immediately. 5. Never smoke or allow a spark or flame in the vicinity of battery or engine. 6. Be extra cautious to reduce risk of dropping a metal tool onto a battery. It might spark or short-circuit the battery or other el...

  • Page 11: Preparing To Charge

    7 preparing to charge 1. If necessary to remove the battery from the vehicle to charge, always remove the grounded terminal from the battery first. Make sure all accessories in the vehicle are off, so to minimize chances of an arc. 2. Be sure area around the battery is well- ventilated while battery...

  • Page 12: Charger Location

    8 charger location 1. Place the battery charger as far away from the battery as the output dc cable permits. 2. Never place the battery charger directly above a battery being charged; gases from battery will corrode and damage the charger. 3. Never allow battery acid to drip on the charger when read...

  • Page 13

    9 to keep the clips from slipping off the terminals and helps to reduce the risk of sparking. Failure to follow these safety guidelines may cause personal injury and/or damage to the xpower charger 2. It may also void your product warranty..

  • Page 14: 3 Xpower Charger 2

    10 3 xpower charger 2 features this section describes the main features of the xpower charger 2. Front panel figure 1 shows the xpower charger 2. Use table 1 to identify the function of items. Figure 1 xpower charger 2 features table 1 xpower charger 2 features item feature 1 mounting flanges for pe...

  • Page 15: Item

    11 2 dc cable the dc cable provides 12 volts, 2 amp charging current to the battery being charged. Three types of adapter accessories are provided for specific needs. (see figure 2.) 3 power light the green power light indicates that ac power is connected to the unit and 12 volts are available at th...

  • Page 16: Dc Cable Connections

    12 dc cable connections figure 2 shows the dc cable connections available for the xpower charger 2. Use table 2 to identify the usage. Figure 2 dc cable connections table 2 dc cable connections usage item function 1 battery clip adapter 2 lighter plug adapter 3 ring terminal adapter 1 2 3.

  • Page 17

    13 warning: shock and fire hazard the battery clip adapter, lighter plug adapter, and ring terminal adapter are to be used individually with the xpower charger 2 as specified in this manual. Connecting adapters together for other, non-specified use will result in reverse polarity and may result in d...

  • Page 18: 4 Charging  A  12 Volt

    14 4 charging a 12 volt battery it is possible to use xpower charger 2 to charge most engine starting batteries when the battery is installed in a vehicle. Before attempting to charge a vehicle battery, make sure the battery is a 12 volt, lead-acid type. Using the lighter plug adapter follow these s...

  • Page 19: Caution

    15 may be necessary to switch the ignition to the accessory setting to allow current to flow from xpower charger 2 to the vehicle battery. 4. Plug the xpower charger 2 ac cord into a standard 115 volt ac outlet. 5. As the battery in your vehicle charges, the green power light and red charging light ...

  • Page 20: Warning: Explosion Hazard

    16 using the battery clip adapter follow these steps to recharge a 12 volt battery using the battery clip adapter: 1. Turn off any lights, audio equipment, or other 12 volt accessories that are connected to your vehicle’s electrical system. Make sure your vehicle is in the park position and secured ...

  • Page 21

    17 6. Determine which battery post is grounded (connected) to the chassis. If the negative post is grounded to chassis (as in most vehicles), see (7) below. If the positive post is grounded to the chassis, see (8) below. 7. For a negative-grounded vehicle, connect the positive (red) clip from the ba...

  • Page 22: Caution

    18 11. When fully charged, the red charging light turns off and the green power on light remains on. The recharge time will vary based on the capacity and discharge state of your vehicle’s battery. 12. Once the vehicle’s battery is fully charged, disconnect the ac cord, remove the clip from the vehi...

  • Page 23: Battery Clip Adapter:

    19 follow these steps to recharge a 12 volt battery outside a vehicle with the battery clip adapter: 1. Check polarity of battery posts. The positive (pos, p, +) battery post usually has a larger diameter than the negative (neg, n, –) post. 2. Attach an insulated battery cable, at least 24-inches lo...

  • Page 24: Caution

    20 6. Plug the xpower charger 2 cord into a standard 115 volt ac outlet. 7. As the battery charges, the green power light and red charging light turn on. 8. When fully charged, the red charging light turns off and the green power light remains on. The recharge time will vary based on the capacity an...

  • Page 25: Terminal Adapter:

    21 using the ring terminal adapter follow these steps to install the ring terminal adapter: 1. The ring terminal adapter’s leads have crimped, color-coded ring terminals (red - positive and black - negative). These lugs connect directly to the corresponding connectors on the battery posts. 2. Remove...

  • Page 26: Caution

    22 follow these steps to recharge a battery using the ring terminal adapter: 1. Disconnect the dc safety cap on the ring terminal adapter. 2. Insert the xpower charger 2’s dc cable to ring terminal adapter connector. 3. Plug the xpower charger 2’s ac cord into a standard 115 volt ac outlet. 4. As th...

  • Page 27: 5 Troubleshooting

    23 5 troubleshooting this section will help you identify the source of most problems that can occur with the xpower charger 2. If you have a problem with the charger, please review this section before contacting xantrex customer service. If you are unable to solve a problem and need to contact xantr...

  • Page 28: Possible Cause

    24 high charging current is detected. The battery being charged requires higher charging current. Use a higher charging current charger (such as xpower charger 15). A heavy load is connected to the battery being charged. Remove the load from the battery. Possible cause solution.

  • Page 29: 6 Specifications

    25 6 specifications specifications are subject to change without notice. Table 3 specifications bulk charging current 2 amps bulk charge to float charge transition voltage (peak charging voltage) 14.3 volts float charge to bulk charge transition voltage (charge restart voltage) 13.0 volts.

  • Page 30: 7 Warranty and Return

    26 7 warranty and return warranty what does this warranty cover? This limited warranty is provided by xantrex technology, inc. ("xantrex") and covers defects in workmanship and materials in your xpower charger 2. This warranty period lasts for 12 months from the date of purchase at the point of sale...

  • Page 31

    27 how do you get service? If your product requires troubleshooting or warranty service, contact your merchant. If you are unable to contact your merchant, or the merchant is unable to provide service, contact xantrex directly at: direct returns may be performed according to the xantrex return mater...

  • Page 32: Disclaimer

    28 what does this warranty not cover? This limited warranty does not cover normal wear and tear of the product or costs related to the removal, installation, or troubleshooting of the customer's electrical systems. This warranty does not apply to and xantrex will not be responsible for any defect in...

  • Page 33: Exclusions

    29 restriction any implied warranty or condition of quality, merchantability or fitness for a particular purpose. Any implied warranty of merchantability or fitness for a particular purpose to the extent required under applicable law to apply to the product shall be limited in duration to the period...

  • Page 34

    30 the use of the xantrex xp ower c harger 2 in connection with life support systems or other medical equipment or devices. Return material authorization policy before returning a product directly to xantrex you must obtain a return material authorization (rma) number and the correct factory "ship t...

  • Page 35: Return Procedure

    31 return procedure 1. Package the unit safely, preferably using the original box and packing materials. Please ensure that your product is shipped fully insured in the original packaging or equivalent. This warranty will not apply where the product is damaged due to improper packaging. 2. Include t...

  • Page 36: Out Of Warranty Service

    32 out of warranty service if the warranty period for your xpower charger 2 has expired, if the unit was damaged by misuse or incorrect installation, if other conditions of the warranty have not been met, or if no dated proof of purchase is available, your product may be serviced or replaced for a f...

  • Page 37: 8 Other Xantrex Products

    33 8 other xantrex products to see the range of inverters and chargers offered by xantrex, visit our web site at: http://www.Xantrex.Com..