Summary of XC-1B
Page 1
User’s manual addendum piqx model: xc-1b.
Page 2
Xc-1b user’s manual addendum table of contents 1. Introduction ..................................................................................................................................................... 1 2. Flatpage ............................................................................
Page 3
Flatpage xc-1b user’s manual addendum flatpage.
Page 4
Flatpage xc-1b user’s manual addendum page 1 1. Introduction this addendum has the instructions on how to use the upgraded perfecapture ver 2.1 with: - flatpage book curve correction technology - dualpage mode which allows scanning of 2 book pages simultaneously take note of the configurations which...
Page 5
Flatpage xc-1b user’s manual addendum page 2 2. Flatpage flatpage technology automatically corrects curved book pages into perfectly flat scans without physically flattening the page. Flatpage is only available when scanning books using the automatic page detection mode for scanning pages without ed...
Page 6
Flatpage xc-1b user’s manual addendum page 3 2.1 flatpage icons switching between single page and dual page modes single page mode: for scanning single book page up to size of a4/letter dual page mode: for scanning 2 book pages simutaneously up to size of a5 scanning from a single book or from multi...
Page 7
Flatpage xc-1b user’s manual addendum page 4 2.2 positioning the book these are instructions specific to flatpage usage in addition to the standard instructions in the main user’s manual (section 5.4: positioning the page) example shows single page mode dual page mode roughly position the center of ...
Page 8
Flatpage xc-1b user’s manual addendum page 5 do not place the book gutter too far away from guide line or overly skewed do not place the book too close to the scan pad labels do not place the book edges outside the scan pad.
Page 9
Flatpage xc-1b user’s manual addendum page 6 book’s gutter is allowed to be slightly away from the guide line or skewed contents near book gutter are not visible due to page lifting. Make sure all contents are clearly visible by using a finger to hold the page down.
Page 10
Flatpage xc-1b user’s manual addendum page 7 2.3 using fingers to flatten book pages for dual page mode 2.3.1 pages on thin side 2.3.2 tightly bound books use a single finger on each side to keep pages from lifting words and book gutter not seen clearly..
Page 11
Flatpage xc-1b user’s manual addendum page 8 2.3.3 precautions on finger placement when flattening book pages 2.3.3.1 do not place fingers at the top and bottom edges of the book pages doing this may result in distorted scans or curve correction failure.
Page 12
Flatpage xc-1b user’s manual addendum page 9 2.3.3.2 do not place fingers at corners of book pages 2.3.4 correct placement of fingers when flattening book pages doing this may result in wrongly cropped scans or curve correction failure place a finger on each page on its left or right edge.