Quick start guide © xcraft enterprises, llc www.Xcraft.Io.
X plusone quick start guide 1. Install pylons: 1. Connect the pylon wires to the wires in the top of the wing as shown below. Connect two bullet connectors and single esc wire. Ensure polarity is correct (red to red, black to black, etc). 2. Insert the pylon spars into the connector on the wing and ...
2. Install propellers: 1. Place the bottom half of the spinner onto the motor then set the propeller over it. 2. Attach the clockwise spinning propellers (r) onto the top and bottom pylon motors and the counterclockwise spinning propellers (no r) onto the wing motors. Ensure writing is facing up. 3....
Long screws 3. Install payload: 1. For the standard nosecone, install as shown in the image below using the supplied hardware: long screws, washers, and nuts. 2. For all other payload options, follow the instructions included with the payload. 4. Charge battery: 1. Connect charger power cord and plu...
5. Controls: 6. Flight modes home return to home craft will return to original take off location fly normal switch position for flight hover manual flight control auto-level will keep craft pointed up when right stick is centered smart hover in place position can be controlled with hover controls. C...
Will maintain its current attitude and will not return to level. Acro mode is useful for forward flight, aerobatics such as flips or rolls, or fpv when smooth and fast control is desired. Auto (set via mission planner(pc) or qgroundcontrol(mac)) autonomous mission x plusone will fly the flight plan ...
10. Arm the craft by holding the left stick of the transmitter down and right for several seconds. 11. Once armed, the motors will begin spinning. rotating propellers can be dangerous. Do not start the motors when there are people nearby. always keep your hands on the remote controller so long a...
