Xenun XT-009 User manual - page 13
XT-009 Gps tracker user manual
13
9.17 SMS Center
z Setup: Send SMS adminsms+password+space+cell phone number to setup the SMS
center.
The tracker will reply Geo-info & authorized number to sms center number even if the admin
numbers call or sending command to the tracker
z Cancel: Send SMS noadminsms+password to cancel the SMS center.
9.18 GSM ID
GSM ID is in each sms or gprs data. The tracker can be found by GSM ID without gps signal. But the
customers have to ask their GSM operator for data base of the GSM ID.
9.19 Motion (Acceseleration)Sensor
z Setup: Send SMS shake+password+space+1-10 to the tracker to set up this function
(1-10 means the level of intensity)
z Send SMS shake+password+space+1 is the least sensitivity . Have to shake the tracker
strongly to get the alert.
z Send SMS shake+password+space+10 is the most sensitivity . Have to shake the tracker
slightly to get the alert
z Cancel: Send SMS shake+password+space+0 to remove this function.
9.20 Micro SD card
Put Micro sd card to the tracker SD card slot. The GPRS data can be saved in the SD card if there
is no gsm/gprs network. It will send data to the GPRS server again after connecting gsm/gprs
network.
z Setup: Send SMS sdlog+password+space+1 to activate the sd card-saving function
z Setup: Send SMS readsd+password+space+1 to ask the tracker to send gprs data in the
SD card to the GPRS server.
z Cancel: Send SMS sdlog+password+space+0 to deactivate this function
z Cancel: Send SMS readsd+password+space+0 to deactivate this function
z Remark: only need to configure one time before using this function.
9.21 ACC status alert
Connecting device to car ACC,when ACC is on ,the tracker will send “accstart “ ,when ACC is off ,the
tracker will send “accstop “
z Alarm format:lat: 22.566923 long: 114.051331 speed: 90.00 28/11/10 03:33 F:4.32V,0,