Xerox DC220ST Quick Install Manual - page 2
7KH'RFXPHQW&RPSDQ\
;(52;
DC220/230/332/340ST Windows NT
®
4.0 (TCP/IP) Scan to File Quick Install
Page 2 of 2
g)
Press [Save].
h)
Press [Login Name], then press
[Edit] and use the keyboard on the
screen to enter the account name for
the DC220/230/332/340ST. Case
sensitivity applies.
i)
Press [Save].
j)
Press [Password], then press [Edit]
and use the keyboard on the screen to
enter the password for the DC220/
230/332/340ST. Case sensitivity
applies.
k)
Press [Save].
3.
Press [Save] to return to the Scan to File
Setups screen.
a)
If required, press [Repository 1] to set
up Repositories 1 through 4. Follow
the steps above to enter the setup
information.
4.
Press [Filing Policy]. Select the desired
Filing Policy.
5.
Press [Confirmation Sheet].
a)
Press [Enable].
b)
Press [Save].
6.
Press [Close] to return to the Scan to File
Setups screen.
7.
Press [Exit].
8.
The DC220/230/332/340ST will
automatically reboot and print a
configuration sheet in approximately 3
minutes.
9.
Check the settings on the configuration
sheet against those that were entered
previously.
10.
Install Visioneer PaperPort
®
software at
each client workstation.
11.
Test the Scan to File feature.
12.
Verify the successful scan by checking the
Confirmation Report printed by the
DC220/230/332/340ST and by checking
the Repository on the server.
Use CentreWare Internet Services
®
, if available
to create templates, or use the default template.
Additional information on this installation can be
found in the DC220/230/332/340ST System
Administration Guide, or the CentreWare
®
manual, Getting Started with Internet Services.
b)
Enter the System Administrator
password by typing
#22222
(# key
and 22222) on the keypad and
pressing [Enter] on the screen.
Note: #22222 is the factory default
and may be changed by your Xerox
service representative to suit your
needs.
2.
Access the Scan to File Setups screens:
a)
On the screen display, press [Scan to
File Setups].
Note: The Job Template Pool and Update All
Templates options on this screen are not used in
this environment.
b)
Press [Default Repository].
c)
Press [TCP/IP].
d)
Press [File Server IP Address], then
press [Edit] and use the keyboard on
the screen to enter the Repository
Server’s IP address.
e)
Press [Save].
f)
Press [Directory Path], then press
[Edit] and use the keyboard on the
screen to enter the path for the
DC220/230/332/340ST account to use
to get to the Repository Directory at
the Server.
©1999 Xerox Corporation
602E60380