Xerox FaxCentre F110 Installation Manual

Installation Guide

Loading Paper

Before your machine will be ready to make 

copies or receive faxes, you must load paper 

into the machine. Use paper letter, 8.5 x 11 

Inch (216 × 279 millimetres). Your machine 

works with normal copier paper and with 

typewriter paper (0.13 – 0,2 lb/m

2

) (see 

user manual chapter Installation / Paper).

1  Separate the paper sheets by fanning 

them out, then align them by tap-

ping edge of the stack lightly against 

a fl at surface. Th

  is will prevent several 

sheets of paper from being drawn in 

all at once.

2  Remove the cover from the paper tray. 

Put in only as much paper as will fi t 

under the raised limit markers on the 

upper edge of the paper input tray 

(see also the drawings on the cover 

of the paper input tray). You can load 

up to 250 sheets into the paper input 

tray.

Document Output 

Tray

Insert the document output tray into the 

two openings under the operation panel.

Document Input Tray

Insert the document input tray into the 

two openings in the cover. Th

 e document 

support should snap securely into place.

Paper Output Tray

Pull the paper output tray out of the paper 

tray cover.

Document input tray

Document guide

Document feed slot

Operation panel

with LCD display

Document 

output tray

Paper output tray

(extendable)

Paper input tray

Opening for

Plug’n’Print card

Cover

3  Press the paper down until the lever 

(A) snaps into place at the rear of the 

paper input tray.

4  Place the cover back on the paper input 

tray. Push the paper input tray into the 

machine all the way to the stopping point.