Xerox FreeFlow version 6.0 System Manual - Snmp Gateway Configuration

1 - 6

System Guide

Gateway and Network Configuration

SNMP gateway configuration

SNMP displays the status of network devices. Using the SNMP 

tab in the Xerox FreeFlow Print Server Gateways, the 

administrator can select among a number of features and settings 

for SNMP.

NOTE: SNMP requires a standard license. The System 

Administrator must enable SNMP in License Manager.

Xerox recommends the following third–party SNMP software 

managers:

•

IBM Network Printer Manager (XP)

•

TNG Unicenter (XP)

•

HP OpenView (UNIX, XP)

•

Xerox CentreWare (UNIX, XP)

NOTE: The SNMP manager (for example, HP OpenView) may 

have a number of requests into the Xerox FreeFlow Print Server 

for information. The requested information may not be among the 

supported data sets on the Print Server. When this occurs, the 

SNMP client/manager displays “no value...etc".

NOTE: You can have more than one SNMP manager running at 

the same time.

Additional features supported in SNMP

SNMP support for the following features are product dependent:

•

The ability to ‘SET’ attributes.

•

The ability to localize text and units of measure.

•

The ability to support a number of MIBs related to finishing and 

printing. 

•

The ability to perform automatic meter reading.

The following table specifies which Xerox products have these 

SNMP supported features:

Table 1-1  

SNMP Supported Features by Product

Feature

DT 61XX 

and DP 

1xx

EPS 1XX

iGen

Nuvera 

1xx

Ability to SET Attributes

Y

Y

N

Y