Xerox Versant 80 Press Installation manual - page 7
Versant 80 Press
Customer Expectation & Installation Guide
3
Finishing Options
IMPORTANT: Refer to Configuration Dependencies for information on configuration requirements for the finishing devices.
High Capacity Stacker (HCS)
The HCS is designed for long production runs:
Top tray has a maximum 500 sheet capacity
Stacking a maximum of 5,000 sheets (based on 80 gsm centerline paper) and offsetting the
output in the stack tray/cart
The movable stack tray/cart provides easy transition of the output to off-line finishing
An additional stack tray/cart is available for the customer to order
Sample prints are additional prints that are directed to the top tray for inspection. Sample
prints are not produced by redirecting sheets from the stack tray/cart to the top tray;
therefore the contents in the stack tray/cart are complete
Standard Finisher
The Standard Finisher features include a basic in- line punch, stapler, the stacker tray, and top
exit tray. It also includes a built-in interposer (inserter) and a built-in decurler unit that corrects
the curl on paper output from the print engine. An optional C/Z Folder is available which
includes the C-Fold, Z-Fold, and Z-Fold Half Sheet. Refer to C/Z Folder for more information.
Booklet Maker Finisher
The Booklet Maker Finisher features include a basic in-line punch, stapler, the stacker tray, top
exit tray, and a booklet unit capable of saddle stapling and bi-fold. It also includes a built-in
decurler unit that corrects the curl on paper output from the print engine and a built-in
interposer (inserter) that feeds cover paper to the finisher for saddle-staple operation. An
optional C/Z Folder is available which includes the C-Fold, Z-Fold, and Z-Fold Half Sheet. Refer to
C/Z Folder for more information.
Standard Finisher Plus
The Standard Finisher Plus includes the functionality of the Standard Finisher and adds
interface/trans- port module to enable connection to third party finishing solutions. An optional
C/Z Folder is available which includes the C-Fold, Z-Fold, and Z-Fold Half Sheet. Refer to C/Z
Folder for more information.
C/Z Folder
This optional unit can perform C-Fold, Z-fold, and Z- Fold Half-Sheet (also called Engineering Z-
Fold). The C/Z Folder can be added to these finishing devices:
Standard Finisher
Booklet Maker Finisher
Standard Finisher Plus
SquareFold
®
Trimmer Module
This optional device is available only with the Booklet Maker Finisher (with or without the C/Z
Folder). The SquareFold Trimmer Module flattens the spine of the booklet and trims the face of
the booklet.
2-Knife Timmer
This optional device is available only with the SquareFold Trimmer module. Provides full-bleed
trim up to 3/16” (5mm) thickness, adjustable trim dimensions, no DFA required.
Other Options
Foreign Interface Kit
The Foreign Interface Kit enables the connection of external devices such as auditrons or coin-
op devices. This will perform in copy and print modes.
Convenience Stapler
Staple up to 50 sheets of 90 gsm/24 lb media.
Common Access Card Enablement Kit
Security feature to identify user based on two-factor identification requirement – access card
plus user PIN.
Network Accounting Kit
Enables reporting and user/device management in combination with optional accounting
solutions.
USB Enablement Kit
Enables scan-to-USB functionality.
Configuration Dependencies
The following dependencies are required for all or certain configurations:
Performance Package
Not compatible with:
BR Finisher
OCT