1. DL manuals
  2. Xerox
  3. Network Card
  4. WNA-100 - Bridge
  5. Setup And Configuration Manual

Xerox WNA-100 - Bridge Setup And Configuration Manual

Other manuals for WNA-100 - Bridge: User Manual, Installation Manual, Specifications, Specifications
Manual is about: Wireless Network Adapter

Summary of WNA-100 - Bridge

  • Page 1

    How to set up and configure the wna-100 wireless network adapter section 1: set up and connect the adapter to a computer, then configure the computer to communicate with the adapter before the adapter can be connected to a printer, it must be connected to a computer so that it can be configured to f...

  • Page 2

    The computer using the ethernet crossover cable. 5. Make sure the computer is configured to use an ip address of 169.254.X.X, where the x characters represent a decimal number between 0 - 254. For example, 169.254.111.113. If necessary, contact the network system administrator. 6. Open an internet b...

  • Page 3

    3. Depending on the information obtained, enter the required settings in the wep, wpa, or eap settings section. For example, if the wireless router uses wep 64 bit encryption, enter the required information in the wep section. The following is an example of settings that need to be configured for th...

  • Page 4

    1. Click on any of the links under the tcp/ip configuration folder on the left of the adapter's web interface. The tcp/ip settings window will be displayed. 2. Select [off] from the bootp/dhcp pull-down menu. 3. Enter an ip address, network mask (also known as subnet mask), and default router in the...

  • Page 5

    Note: for additional information about the various administrative settings, click on the [help] button at the top, right of the window. Section 5: reset the adapter to save all settings, then connect the adapter to the printer 1. Click on the [restart] button in the reset section on the administrati...