XG Technology xMax CN1300 Installation Manual - page 5
5
xMax 2.4 GHz Access Point - Installation Guide - G7606 - Release 1.0
The CN1300 xMax
©
2.4 GHz Access Point is a best-in-class outdoor-rated 802.11 access point and
antenna combination. The compact size and weight allows for easy installation on towers, buildings,
or utility poles. The unit is PoE (Power-over-Ethernet) powered, again enabling easy implementation.
The CN1300 is a full-function access point providing up to 100 Mbps user throughput.
Up to 200 clients can associate with this access point.
The AP supports 802.11 G/N modes of operation.
Configuration can be done through a user-friendly GUI.
WPA/WPA2 security is supported.
Multiple SSIDs can be broadcast to support different network organization.
QoS and priority traffic is supported.
The CN1300 can operate as a standalone 802.11 AP supporting smart phones, laptops, cameras, and
tablets that are WiFi enabled. When combined in a system configuration, with CN1100 access points
and CN3200 routing modems, the CN1300 can participate in a wide-area mobile network supporting
handoff.
This manual provides basic instructions for the installation and configuration of the CN1300 Access
Point. It also describes how to connect to the xMax Network and then connect Internet-enabled
wireless devices to the xMax Network.
The CN1300 Access Point is shipped with the parts needed for basic installation and operation. These
items are shown below. Be sure each of these items is included in your product package. If any item is
missing, please contact the place of purchase.
Depending upon the requirements of your installation, you will also need to purchase additional
components such as cables and surge protectors. A checklist of typically required parts is shown in
the Installation section.
CN1300 xMax 2.4 GHz Access Point
and Mounting Hardware
PoE Power Supply
and AC Power Cord
Ferrite Beads (3)