XG Technology xMax CN1300 Quick Start Manual - page 8
8
xMax 2.4 GHz Access Point - Quick Start Guide - G7605 - Release 2.0
IMPORTANT
Before you begin this step, it is assumed that the CN1300 xMax 2.4 GHz Access Point has been
configured as described in the CN1300 xMax 2.4 GHz Access Point Installation Guide.
The configuration was completed by the device installer.
These steps connect the CN1300 Access Point to an xMax network.
1. Connect the power cable on the PoE++ Power Supply to a 110 to 240 VAC power source.
2. Connect to the IP address provided by the installer.
3. Initially, it will take up to two minutes to connect to the xMax Network.
4. The CN1300 xMax 2.4 GHz Access Point is now fully functional.
NOTES
If the CN1300 Access Point fails to connect to an xMax network after two minutes have
elapsed, ensure that the power indicator on the Power Supply is glowing
GREEN
.
If the after two minutes have elapsed, follow these steps to restart the CN1300 Access Point:
Power off the CN1300 Access Point by disconnecting the AC cord from the Power Supply.
Wait 60 seconds.
Reconnect the AC cord to power on the CN1300 Access Point.
If the CN1300 Access Point still does not connect to the xMax Network, call the service provider
to report your problem.