Antai solar mounting rack compliance to as code 1170 1 xiamen antai new energy tech.Co., ltd installation manual—antai rail solar mounting system (flat roof solution) version 1.1 office add: 508#, north tower, guangxia building huli torch hi-tech zone, xiamen, china factory add: guanshan industrial ...
Antai solar mounting rack compliance to as code 1170 2 antai flat roof mounting system antai flat roof mounting system has been developed as a universal pv module mounting system for flat roof or open space ground installation. The innovative and the high degree of pre-assembly eliminate the need fo...
Antai solar mounting rack compliance to as code 1170 3 i. Components list overview of system components part name picture part name picture antai rail- fix foot splice adjustable leg strut inter clamp (with t-module) end clamp (with t-module) t-module hexagon socket bolt m8*12/30/50/70 klamp lock 70...
Antai solar mounting rack compliance to as code 1170 4 ii. Planning the module area 1. Number of modules in the vertical direction × module height (please check also the installation manual of the manufacturer of the solar panel) 2. Number of module in horizontal direction× (module width+17mm)+32mm ...
Antai solar mounting rack compliance to as code 1170 5 figure 3.1 wind regions flat roof maximum fixing spacing table—antai rail fixed to flat roof with minimum of 2 x 12 gauge (5.5mm min. Diameter, 14 tpi and 10 tpi for fixing to steel and timber respectively) screw through to 1.2mm min. Bmt steel ...
Antai solar mounting rack compliance to as code 1170 6 iii. Installation instruction 1. Determine the positions of the fix foot according to your plans and the fixing spacing table on the previous page. Shim the fix foot with rubber. Fix the fix foot to the rafter using 2*12g screws as notes in the ...
Antai solar mounting rack compliance to as code 1170 7 4. Put the u bracket into the front fix foot .It is recommended to mount them just a bit tight, so it could be adjusted in the mounting and fasten completely. Fix the u bracket with the rail by t module use m8×30mm bolt. 5. Base rail installatio...
Antai solar mounting rack compliance to as code 1170 8 8. Fix the l bracket with the leg tube by using m8×50mm bolt. 9. Fix the bracket with the basic rail by t module use m8×30mm bolt. 10. If you need, to connect multiple rails together, slide the splices on the rear side of the pre-assembled rails...
Antai solar mounting rack compliance to as code 1170 9 12. Place the solar module on the rails, slide the end clamp tightly against the solar module and fasten tightly using the allen bolt. 13. Cross-section through the end clamp when installation step12 has been correctly performed. 14. Slide the p...
Antai solar mounting rack compliance to as code 1170 10 16.Place the last module in the row on the rails (with the first row of modules, take care that the anti-slip protection sits properly in the rail channel) and fasten the last inter clamp and the end clamp using the allen key. 17. Leg strut and...
Antai solar mounting rack compliance to as code 1170 11 v. Warranty 10 year limited product warranty, 5 year limited finish warranty antai solar ltd warrants to the original purchaser (“purchaser”) of product(s) that it manufactures (“product”) at the original installation site that the product shal...
