XIEGU X1M Pro User Manual - page 10
10
Notes
This will save you some headaches later on. Keep your notebook handy to make notes in for the
actual operation of your X1M PRO. Also, note any problems and what you were doing when the
problem showed up.
Everyone should access the SYSTEMS MENU and record the present values currently stored for
each item in the list. This will allow you to restore these values in the case they get changed for
some reason. These values are typical as of release V1.021 of the firmware:
Acknowledgments
The authors would like to acknowledge specific contributions from the following people:
Ray Motte, KD4HJT, for the photos of the rear panel of the X1M and the side tone trim pot.
Ken Fest, N2LZV, for the photos of the front of the X1M and various screen shots.
Ed Griffin, W4KMA, for providing the initial manuals and answering all sorts of questions, as well
as the photo of the front of the transceiver, and firmware update material.
John Tracy, W6SB, for discussions on circuit internals and SWR considerations.
Steven Johnston, WD8DAS, Ken Downs, W1KRT, Heath, VK3TWO/VK6TWO,
and Mark Francis, KI0PF for help with the alignment procedures. Heath also provided the
firmware update procedure, which we have edited for this manual. Dale Parfitt, W4OP, for
clarifying the issues in adjusting CW operation.
Volkmar Junge, DF2SS of WiMo Antennen und Elektronik GmbH, Ed Griffin, Dale Parfitt, and
Charlie Vest for working with the factory on firmware and hardware issues.
The Yahoo News Group members of the X1M transceiver group for many helpful suggestions,
critiques, and comments.
Frederick A. Lesnick, VE3FAL, Thunder Bay, Ontario
Paul W. Ross, W3FIS, Fenwick Island, Delaware
Charles O. Vest, W5COV, South Coffeyville, Oklahoma
Function
Factory
My
Settings
01 IF OFST
08999850
02 LSB BFO
08998750
03 USB BFO
09000950
04 CW BFO
08999850
05 CW TONE 0800
06 CW TDLY 0300
07 KYR SPD
020
08 TXP TIM
0000
09 BRITNES 100
10 CNTRST 100
11 FBND 0
12 DDS CLK
032768000
13 DDS MLT
1
14 RST ALL
0