Xilica Audio Design NEUPANEL MINI Product Installation Manual - page 3
Surface Mount
Included with each Mini control is a surface mount back box that the Mini comes mounted into
inside the product carton. This back box is designed to be mounted externally on a wall or surface.
The surface back box has an angled mounting surface that allows the Mini control to be rotated to
meet the desired view angle and is secured to the back box with 4 x M8 metric screws.
Note:
It is always recommended before installing the device to disconnect the power to prevent
the power from shorting to the chassis.
Flush Wall Mount
Mini controls can be flush in-wall mounted in new or existing construction applications. It is very important to read this guide in its
entirety before starting your installation.
Note:
Each Mini model comes in its carton inserted into a surface mount angled back box. Remove the Mini from our back box. The 4
screws are M8 metric thread. These screws cannot be used in electrical boxes in N. America. Use the 4 x #6-32 SAE screws that come
in a bag with each Mini for installations in N. America.
It is extremely important that the Mini control is NOT powered on during the installation or removal process. The circuit board can
short out against the metallic box, damaging the hardware, and possibly the PoE switch.
For
New Work Construction
, a 4" x 4" electrical back box with a minimum depth of 2" and a mud ring (if used) with a depth of 1⁄2" for
proper clearance are required.
Note:
If mud rings are used - they may vary slightly depending on the manufacturer and depth of the ring itself. It may be necessary
to modify the corners of the mud ring for proper fit. The corners on the mud ring as shown below right have a larger radius than the
one on the left and will need a bit of filing for the Mini wall controller to fit. (The Appleton 1⁄2" mud ring shown at the left below will fit
without modification)
Under very special situations the wall controller may have to be installed “Live” or in a
powered on state. This is NOT recommended, however, it is possible to insulate the left
portion of the mud ring with a large piece of electrical tape. This will insulate it from the
circuit board while sliding the wall controller through the opening of the mud ring.
Small Radius
Fits Perfectly
Larger Radius Will
Need Modification
Electrical Tape Provides Insulation
Circuit Board Requires Protection