Xilica Audio Design RIO R22 Quick Start Manual - Quick Start Guide
Quick Start Guide
Rio Series
–
R22 and R44 Models
___________________________________________________________________
Xilica Audio Design Canada
Page 4
www.xilica.com
R22-P and R44-P Models
(Rear of R44-P Example Shown)
6.
External Power Supply Connector
An external 12VDC
– 1 Amp power supply is included with each R22-P and R44-P interface model. Or power using PoE via the
network cable and a PoE switch or router.
7.
Analog Audio - Output Connectors
Two dual output - 6 pin 3.81mm Euro terminal block connectors for analog audio output on the R44-P (one dual output connector for
the R22-P model).
8.
Analog Audio - Input Connectors
Two dual input - 6 pin 3.81mm Euro terminal block connectors for analog audio input on the R44-P (one dual input connector for the
R22-P model).
9.
Surface Mount Brackets
A pair of removable surface mount brackets are included (shown attached to the R44-P above) that allow mounting the R22-P and
R44-P models to rear rack rails, rack shelves, or to any surface.
R22-WP-X and R22-WP-M Models (Front of Each Model and the Rear for Both Shown Below)
R22-WP-X R22-WP-M
Snap On Cover
Main Body Panel
10.
Power Status LED
A front panel power status LED will light to indicate that the interface device is connected to a power source.
11.
XLR Inputs
– Front Panel Mic/Line and Phantom Power Selection & Status LED’s
Select Mic or Line input for both models on a per input basis using a sharp object to access the recessed on/off switches on the front
panel. Select 48v phantom power on/off for each XLR input in the same manner. Individual status LEDs light when Mic input is
selected and when Phantom power is engaged.
12.
XLR Outputs
Two (2) XLR line level outputs are provided on the R22-WP-X and a single XLR line output on the R22-WP-M model.
13.
3.5mm & RCA Inputs / 3.5mm Output on the R22-WP-M Model
The R22-WP-M model provides 3.5mm and dual RCA line inputs (both L+R summed) and a L+R summed 3.5mm line output.
14.
External Power Supply Connector / Front Cover Screwdriver Slot
– Front Cover Removal
An external 12VDC power supply is included with each R22-WP-X and R22-WP-M model. We recommend
powering all our R22 and R44 interface models and in particular these R22-WP wall mount models using PoE power via the network
cable and a PoE switch or router.
Locate
front cover slot & use a screwdriver to assist removal of snap on outer front cover
.
15.
Rear panel - Dante Network Audio RJ-45 Connector
Use Cat5, Cat6 or better network cable to connect the Rio R22-WPX and R22-WP-M devices to your Dante network.