Xilinx ML505 Quick Start Manual

Other manuals for ML505: Quick Start Manual

Summary of ML505

  • Page 1

    Ml505/506 quickstart may 2008.

  • Page 2: Overview

    Overview • setup • boot with ace-loader ace file • observe lcd and terminal messages • load new configuration • re-load ace-loader.

  • Page 3: Ml505 Bsb Hardware

    Ml505 bsb hardware • the ml505 microblaze design hardware includes: – ddr2 interface (256 mb) – bram – external memory controller (emc) • zbt sram – networking – uart – interrupt controller – system ace cf interface – gpio (iic, leds and lcd) – plb arbiter note: presentation applies to the ml505 and...

  • Page 4: Additional Setup Details

    Additional setup details • refer to ml505_overview_setup document for details on: – software requirements – ml505 board setup • equipment and cables • software • network – terminal programs • this presentation requires the 9600-8-n-1 baud terminal setup note: presentation applies to the ml505 and ml...

  • Page 5: Hardware Setup

    Hardware setup • connect the xilinx parallel cable iv (pc4) to the ml505 board • connect the rs232 null modem cable to the ml505 board note: presentation applies to the ml505 and ml506.

  • Page 6: Hardware Setup

    Hardware setup • the ml505 uses a dvi video interface • connect a dvi monitor or • use a dvi/vga adapter to connect a vga monitor – http://www.Belkin.Com note: presentation applies to the ml505 and ml506.

  • Page 7: Hardware Setup

    Hardware setup • usb keyboard – www.Dell.Com note: presentation applies to the ml505 and ml506.

  • Page 8: Factory Compactflash

    Factory compactflash • the compactflash shipped with the ml505 board has the following ace files preloaded: note: presentation applies to the ml505 and ml506.

  • Page 9

    Verify factory default settings • set the ethernet phy jumpers, j22, j23 to positions 1-2 (1) • insert the factory compactflash into the ml505 board (2) • set the front dip switches (sw3) to 00010101 (1 = on) (3) • set the rear dip switches (sw6) to 11001010 (4) • power-up the ml505 board 4 note: pr...

  • Page 10: Bootload

    Bootload • the system_bootload.Ace loads: note: presentation applies to the ml505 and ml506.

  • Page 11: Bootload

    Bootload • the terminal window also reflects the bootload application • use the left/center/right buttons to choose an application or type a number in the terminal window • after each demo, push the sysace reset to return to bootload note: presentation applies to the ml505 and ml506.

  • Page 12: Slideshow

    Slideshow • type 1, to launch the slideshow application in configuration 1 • the slideshow loads the presentation into memory then presents it note: presentation applies to the ml505 and ml506.

  • Page 13: Slideshow

    Slideshow • the slideshow app will present a series of slides on the monitor: note: presentation applies to the ml505 and ml506.

  • Page 14: Web Server

    Web server • type 2, to launch the web server application in configuration 2 – note: you may need to turn off your browser's proxy and specify a direct connection to the internet in your browser options note: host ip is 1.2.3.9, subnet mask is 255.0.0.0; ethernet connection is 100 full duplex.

  • Page 15: Web Server

    Web server • in your web browser, enter http://1.2.3.4:8080/index.Html note: presentation applies to the ml505 and ml506.

  • Page 16: Simon

    Simon • type 3, to launch the simon application in configuration 3 note: presentation applies to the ml505 and ml506.

  • Page 17: Board Diagnostics

    Board diagnostics • type 4, to launch the xrom application in configuration 4 note: presentation applies to the ml505 and ml506.

  • Page 18: Board Diagnostics

    Board diagnostics • xrom includes a series of board test routines note: presentation applies to the ml505 and ml506.

  • Page 19: Usb Keyboard

    Usb keyboard • type 5, to launch the usb keyboard application in configuration 5 • type ml505 and view results: note: presentation applies to the ml505 and ml506.

  • Page 20: My Ace

    My ace • type 6, to launch the my ace application in configuration 6 note: presentation applies to the ml505 and ml506.

  • Page 21: Ringtone

    Ringtone • type 7, to launch the ringtone application in configuration 7 • press any key then press 1-7 to play a simple melody note: presentation applies to the ml505 and ml506.

  • Page 22: Documentation

    Documentation • virtex-5 – silicon devices http://www.Xilinx.Com/products/silicon_solutions – virtex-5 multi-platform fpga http://www.Xilinx.Com/products/silicon_solutions/fpgas/virtex/virtex5 – virtex-5 family overview: lx, lxt, sxt, and fxt platforms http://www.Xilinx.Com/support/documentation/dat...

  • Page 23: Documentation

    Documentation • virtex-5 – virtex-5 fpga user guide http://www.Xilinx.Com/support/documentation/user_guides/ug190.Pdf – virtex-5 fpga configuration user guide http://www.Xilinx.Com/support/documentation/user_guides/ug191.Pdf – virtex-5 system monitor user guide http://www.Xilinx.Com/support/document...

  • Page 24: Documentation

    Documentation • virtex-5 rocketio – rocketio gtp transceivers http://www.Xilinx.Com/products/silicon_solutions/fpgas/virtex/virtex5/ capabilities/rocketio_gtp.Htm – rocketio gtx transceivers http://www.Xilinx.Com/products/silicon_solutions/fpgas/virtex/virtex5/ capabilities/rocketio_gtx.Htm – rocket...

  • Page 25: Documentation

    Documentation • microblaze – microblaze processor http://www.Xilinx.Com/microblaze – microblaze processor reference guide – ug081 http://www.Xilinx.Com/support/documentation/sw_manuals/mb_ref_guide.Pdf.

  • Page 26: Documentation

    Documentation • memory solutions – demos on demand – memory interface solutions with xilinx fpgas http://www.Demosondemand.Com/clients/xilinx/001/page_new2/index.Asp#35 – xilinx memory corner http://www.Xilinx.Com/products/design_resources/mem_corner – additional memory resources http://www.Xilinx.C...

  • Page 27: Documentation

    Documentation • ethernet – virtex-5 embedded tri-mode ethernet mac wrapper data sheet http://www.Xilinx.Com/support/documentation/ip_documentation/ v5_emac_ds550.Pdf – virtex-5 embedded tri-mode ethernet mac wrapper getting started guide http://www.Xilinx.Com/support/documentation/ip_documentation/ ...

  • Page 28: Documentation

    Documentation • ml505/506/507 – ml505 overview http://www.Xilinx.Com/ml505 – ml506 overview http://www.Xilinx.Com/ml506 – ml507 overview http://www.Xilinx.Com/ml507 – ml505/506/507 evaluation platform user guide – ug347 http://www.Xilinx.Com/support/documentation/boards_and_kits/ug347.Pdf – ml505/50...

  • Page 29: Documentation

    Documentation • ml505/506/507 – ml505/506/507 schematics http://www.Xilinx.Com/support/documentation/boards_and_kits/ ml50x_schematics.Pdf – ml505/506/507 bill of material http://www.Xilinx.Com/support/documentation/boards_and_kits/ ml505_501_bom.Xls.