Xinpu XP-G50VB Handling Instructions Manual - Lubrication
Sometimes the power tool does not begin the striking the stroke even the motor keep running, because oil
inside become thick. If the power tool is used at a low temperature, or it is used after a long idle time, this
demolition hammer should be kept running for above 5 minutes to warm up.
Changing the Chiselling Position (Vario-lock)
The chisel can be locked in 12 positions. In this manner, the optimum working position can be set for each
application.
Insert the chisel into the tool holder.
Push the Move limited ring 3 forward and turn the chisel to the required position with the Move limited
ring 3.
Release the Move limited ring 3 and turn the chisel until it latches.
Shock absorption Equipment 5
The XP-G50VB is equipped with an active vibration reduction system, which cuts vibration of that of the
without Active Vibration Reduction. This may significantly reduce the exposure level over the total
working period. protect the operator form the effects of vibration.
Setting the Impact Rate
The electronic control enables stepless speed preselection in accordance with the material to be worked.
The constant electronic control keeps the preselected impact rate nearly constant between no-load and
load conditions.
Select the impact rate with the Speed Adjuster Function Knob 7 according to the material.
LUBRICATION
This machine is of full air-tight construction to protect against dust and to prevent lubricant leakage.
Therefore, the machine can be used without lubrication for long periods. Replace the grease as described
below.
1. Grease replacement
Ask for grease replacement at the nearest XINPU Authorized Service Center. Proceed for replacement
of grease.
2. Grease replenishment
CAUTION:
Before replenishing the grease, turn the power off and pull out the power plug.
(1) Remove the oil tank cover 4 and wipe off the grease inside.
(2) Supply 30g of XINPU Grease (Standard accessory, contained in tube) to the crank case.
(3) After replenishing the grease, install the oil tank cover 4 securely.
NOTE:
The XINPU Grease is of the low viscosity type. If necessary purchase from an XINPU
Authorized Service Center.