Xinpu XP-G55B Handling Instructions Manual - Name of The Parts

  Name of the parts 

1.  Hammer rod protector 

2.  Protective lining   

3.  Move limited ring 

4.  Switch Push-And-Pull   

5.  Speed Adjuster Function Knob 

6.  Indicator 

7.  Side Handle 

8.  Function Knob 

Assembly

Auxiliary Handle 

Operate your power tool only with the Side Handle7. 

The Side Handle 7 can be set to any position for a secure and low-fatigue working posture. 

Loosen the Function Knob 8, rotate the Side Handle 7 around the axis of the power tool to the required 

position and tighten the Function Knob 8 again. 

The Side Handle7 can be mounted to a different position. For this, completely unscrew the Function Knob 

8 and then pull out the hexagon bolt upward. Pull off the Side Handle 7 to the side and turn around the 

remaining clamping element by 180

。

Mount the Side Handle 7 in reverse order. 

Changing the tool 

Before any work on the power tool itself, pull the mains plug. 

With the SDS-max tool holder. Simpler and easier tool changing is possible without additional aids.   

The Hammer rod protector 1 largely prevents the entry of drilling dust into the tool holder during 

operation. When inserting the tool, take care that the Hammer rod protector 1 is not damaged. 

A damaged Hammer rod protector should be changed immediately. We recommend having this carried 

out by an after-sales service. 

Inserting (see figure A) 

Clean and lightly grease the shank end   

of the tool. 

Insert the tool in a twisting manner into 

the tool holder until it latches itself. 

Check the latching by pilling the tool. 

Removing (see figure B) 

Push back the Protective lining 2 and remove 

the tool.