Demolitionhammer model: xp-g90b handling instructions original instructions before using this xinpu demolition hammer, please carefully read though these handling instructions. Ensure that you know how the machine works, and how it should be operated. Maintain the machine in accordance with the inst...
2 application this hammer should be applied to breaking concrete, chipping off concrete, grooving, bar cutting, and driving piles in installation of piping and wiring, unitary facility installation, machinery installation water supply, and drainage work, interior jobs, harbor facilities and other ci...
3 optional accessories（sold separately） notice: optional accessories (sold separately) are recommended only for xinpu tool for specified purpose in manual, any otherbrand accessories or attachments used may present risk of injury. 1. Bull point hexagon size28*530 length (unit:mm) 2. Flat chisel hexa...
4 in this operator's manual/or machine’s labels following symbols are used: read the manual carefully accordance with essential applicable safety of european directives double insulation denote risk of personal injury, loss of life or damage to the tool in case of nonobservance of the instruction in...
5 2) electrical safety a) power tool plugs must match the outlet. Never modify the plug in any way. Do not use any adapter plugs with earthed (grounded) power tools. Unmodified plugs and matching outlets will reduce risk of electric shock. B) avoid body contact with earthed or grounded surfaces such...
6 these are connected and properly used. Use of these devices can reduce dust related ha2ards. 4) power tool use and care a) do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. B)...
7 1. Wear a hard hat (safety helmet), safety glasses and /or face shield. It is also highly recommended that you wear a dust mask, ear protectors and thickly padded gloves. 2、be sure the bit is secured in place before operation. 3. Under normal operation, the machine is designed to produce vibration...
8 name of the parts 1 bit 2 lock 3 holder 4 aluminum encloser 5 housing 6 handle 7 switch trigger 8 fan cover 9 side handel mounting tool bits warning: before do it, make sure unplug the machine! Fig1 fig2.
9 clean the shank of bit and put some grease the assembly of bit without the shoulder(with groove) (see fig 1 & fig 2) operate the lock part 2 to 150 degree position, insert the bit 1 into the holder 3. Operate the lock part 2 back, pull the bit 1 to check if it was locked. When disassembling, repea...
10 prior to operation 1. Power source ensure that the power source to be utilized conforms to the power requirements which specified on the name plate of the hammer. 2. Power switch ensure that the power switch is in the position of off. If the plug is connected to power receptacle while the power s...
11 warning! Pull plug from power before any operations. Demolition hammer mechanical part is easy to get worn and lose impact energy if without enough lubrication, recommend filling grease and oil after 6 months usage. The steps as follows: fig 1 fig 2 fig 3 fig 4 fig 5 fig 6 fig 7 fig 8 1. Loosen t...
12 o-ring is less than the piston o.D., please replace the o-ring to get proper performance.(please contact with our authorized dealer to purchase, the part no 56). 5. Fill the grease into the aluminum head, please make sure cleaned inside before filling. A) recommend the grease from manufacturer si...
13 1 φ6 plat washer hexagon socket bolt m6x20 2 fan cover 3 the cover of carbon bush holder 4 carbon brush loosen the four set screws and remove the fan cover. Remove the brush caps and carbon brushes. After replacing the carbon brushes, tighten the brush caps securely and install the fan cover with...
14.
15.
