Xitel MD-PORT User Manual - page 8
13
12
mark to appear by using the same technique to move the marker in the bottom preview window as you
used in the top preview window. Super fine tuning can be achieved by using the arrow buttons that appear
next to the End track time. You will notice the red vertical bar in the bottom preview window moving as
you adjust using these buttons. Keep using the Play button in the Preview controls to check the ending of
Track 1 is correct. When you’re happy, hit the Forward button in the Preview controls section to jump to
the beginning of Track 2.
7. You’ll notice that LPRipper will now move to the start of Track 2. You can move and set the start of Track
2 exactly the same way that you set the end of Track 1. You should move the Track 2 beginning marker to
where the end marker of Track 1 was. By using the Forward and Rewind buttons in the Preview controls
you can swap between the ending of Track 1 and the beginning of Track 2 so that they match up. When
you’re done, hit the Forward button to move to the end of Track 2 so that you can also set this. Keep
using the Play button in the Preview controls to check your settings. Continue to do this until all tracks
have been set.
Note: LPRipper has a number of other powerful features that will let you set and trim tracks. You should
consult the user manual for further details by going to Help and then Content and Index in LPRipper.
Please note that it is important you familiarize yourself with this manual as Xitel Technical Support can
only offer limited assistance surrounding this software.
8. After you’ve finished setting all of your track marks
hit OK to close the Trim Tracks window. All of your
tracks will now appear with start and finish times.
If you go to Edit and then Edit Tracks you can
enter the names of your new tracks.
9. If you go to File then Save, these tracks will be
saved as new individual wav files with the names
you have given them. If you’re happy with how
they sound, you may want to delete the large wav
file that was created when you did your original
You should become very familiar with navigating LPRipper by looking at whether the check mark appears
next to Start or Finish and what Track you are currently working on.
6. If the end track mark of Track 1 does not fall at the end of the song, you can manually move it to where
the track ends. If the track mark appears a long way from where the track actually ends, move your mouse
cursor over the red vertical line in the top track screen. When it turns to a left/right move cursor, left click
your mouse button and drag the line to the end of the track. It is easy to distinguish where the end of a
track should be, as the audio wave will drop down like a valley. If you look at the preview in the top
window in this example, you can see that there are four tracks separated by three valleys. If you then look
in the bottom preview window, you can see there is a point where the audio reaches a zero level. This is
where there was a track mark between tracks on your MD. You can fine tune where you want the track