Xmart SNMP06 Reference Manual

SNMP06 LAN CARD 

REFERENCE MANUAL 

_______________________________________________________ 

SNMP-06  (161212)                                                                                                                  1 

ENGLISH 

1.- INTRODUCTION 

SNMP06 is a powerful and versatile communication LAN card for XMART online UPS. This card 

includes functions as: 

-  Communication for LAN Ethernet under protocols TCP/IP, UDP, SNMP, SMTP, SNTP, HTTP, HTTPS, 

SSL, SSH, IPV4/IPV6, DHCP, etc. 

-  Connection to external XMART environmental sensor to acquire and send temperature/humidity data 

to the network. 

-  10M/100M autodetection speed 

-  Internal data logging up to 200.000 events/alarms 

-  Interface to monitor and control main parameters of the UPS 

2.- DESCRIPTION 

A:  

LAN Ethernet (10/100MB) 

B:  Sensor 

T/H 

C:  

Reset Jumper: To reestablish default values 

   1-2: Normal 

   2-3: Reset: Revise note 1 

SNMP06 LAN CARD 

REFERENCE MANUAL 

_______________________________________________________ 

SNMP-06  (161212)                                                                                                                  2 

D:  

LED green = ON: 100MB / OFF: 10MB 

E:  

LED yellow = ON: connection detected / OFF: connection not detected  

NOTE 1: RESET: Reset function reinitializes card with factory values. It also eliminates user passwords 

To apply a reset follow next procedure: 

1)  Remove card from UPS and set jumper between pins 2 & 3 (revise previous image) 

2)  Insert card into the UPS and wait during 5 minutes meanwhile reset is performed. 

3)  Remove card from UPS again and set jumper between pins 1 & 2. 

4)  Reinsert card into the UPS and wait during 5 minutes meanwhile card restarts with factory 

setting. 

Factory setting after reset:  

IP: 192.168.102.230 (STATIC IP) ;  

Subnet Mask: 255.255.255.0 ; Default gateway: 192.168.102.1 

Password: 12345678 

3.- INSTALATION  

1: Remove cover from intelligent slot in the UPS 

2: Check jumper “C” is between pins 1 & 2 in the card 

3: Plug RJ45 cable in the Ethernet port of the card and connect other side to the network socket. 

Check if yellow LED lights as expected. 

If TH sensor is available, connect it to its related RJ11 port in the card according to next figure. 

We strongly suggest to check TH sensor manual. 

LAN

SENSOR TH

RJ11 

RJ45