DL manuals
Xomax
Car Seat
XM-K1
Instruction Manual

Xomax XM-K1 Instruction Manual

Page of 8

Download

Print this page

Bookmark us

Car Seat

Instruction Manual

GROUP 1, 2, 3

Suitable for Children

9-36kg

INSTRUCTIONS

ABOUT COVER

DO NOT use the this car seat without the car seat cover.

The cover can be removed for cleaning,but not recommend for constant

remove.Once you removed the cover,you should install it per the original

structure and make sure no component is missing or incorrectly installed.

Spot clean with mild soap and warm water.

No bleach,solvent or powerful soap.

DO NOT detach,remove or change any structure and component of baby

seat cover or harness system.

DO NOT add any lubricant or other chemical agent on the seat cover and

harness system.Shoulder pad and crotch pad is hand wash only (

and dry flat.DO NOT dry clean or tumble dry and away from direct heat.

WARNING

Please read all instructions in this manual carefully before using.

Please retain this instruction manual for future use.

The child seat MUST be used with 3 point vehicle seat belt when used

as child restraint with harness.

Please use this car seat with great caution if your car equipped with SRS.

DO NOT use a second-hand child car seat or assign this type of products.

DO NOT put this car seat on high place.

HAND WASH ONLY (30

Warm)

Use Mild Detergent

Do not Iron, Dry Clean, Bleach or Tumble Dry

Dry flat - away from direct heat

DO NOT USE BLEACH, ABRASIVE

OR UPHOLSTERY CLEANING AGENTS

Made for STEL Multimedia GmbH,

Paewesiner Weg 20,

13581 Berlin,

GERMANY

Read all instructions before using this child restraint,keep instructions for

future use.If these instructions are not followed, the safety of a child may

be severely endangered.

1 2 3 4 5 6 7 Next › »

Summary of XM-K1

Page 1
Car seat instruction manual group 1, 2, 3 suitable for children 9-36kg instructions about cover do not use the this car seat without the car seat cover. The cover can be removed for cleaning,but not recommend for constant remove.Once you removed the cover,you should install it per the original struc...
Page 2
This is a “universal” child restraint. It is approved to regulation no. 44, 04 series of amendments, for general use in vehicles and it will fit most, but not all, car seats. A correct fit is likely if the vehicle manufacturer has declared in the vehicle handbook that the vehicle is capable of accep...
Page 3
Setup parts list 3 4 xomax xomax 1.Headrest 2.Belt guide 3.Harness strap 4.Harness pad 5.Harness buckle 7.Headrest strap 8.Seat 9.Harness slots 10.Metal yoke 11.Headrest adjust button 12. 1 6 7 3 4 11 9 10 12 5 2 6.Harness adjuster buttom(under cover) lift backrest,push the hook into slots of booste...
Page 4
5 6 xomax xomax adjusting harness height adjusting harness length five point harness positioning 2 a 3 4 b a 1 5 6 5.Press the harness adjuster button and at the same time pull bothharness straps. 6.Position the height of harness according to the child’s height.The harness straps should be level wit...
Page 5
A b a 7 8 xomax xomax child restrant with harness (9-18kg child) a b a a 7 9 put the child restraint onto a forward-facing vehicle seat . Route the vehicle belt latch plate ,from the front of the child restraint towards the back through the slot of the front of the backrest . Route the belt around t...
Page 6
Adjusting headrest height a b b 9 10 xomax xomax remove the 5 point harness 10 d c d from the back of the carseat can release the velcro of the shoulder. From the bottom of the carseat can take over the metal plate, then remove all 5 point harness. Remove the metal plate, need cut of the front of th...
Page 7
B a 11 11 12 xomax xomax a b child restraint without harness (15-36kg child) put the child seat on a forward-facing vehicle seat. Adjusting headrest height(see 9 pic). Have the child sit on the booster seat so their back contacts the backrest from shoulders to bottom. Removing the cover remove the h...
Page 8
13 14 xomax xomax approval.